Provided by: amanda-common_3.5.1-1ubuntu0.3_amd64 bug

NAME

       amanda-interactivity - Configuring Interactivity with Amanda Amanda

DESCRIPTION

       Amanda uses interactivity to ask user to load specific volumes when they are needed. This
       manual page describes the interactivity modules included with Amanda.

       This is a user-level description of the API, and does not address details that are only of
       concern to developers of new interactivity plugins. For that purpose, consult the Amanda
       source code, perldoc 'Amanda::Interactivity' and http://wiki.zmanda.com.

DEFINING INTERACTIVITY

       Interactivity is specified in amanda.conf(5) as follows:

       define interactivity $interactivity_name {
          comment "$comment"
          plugin "$pluginname"
          property "$PROPERTY_NAME" "$PROPERTY_VALUE"
          ...
       }
       and then referenced in the global section as

         interactivity "$interactivity_name"

       Interactivity properties, like Amanda configuration parameters, are insensitive to case,
       and - (dash) and _ (underscore) may be used interchangeably.

       See the individual plugin sections, below for properties applicable to each plugin.

INTERACTIVITY MODULES

       Amanda provides three interactivity modules, tty, email and tty_email.

   TTY
       The tty interactivity module uses the tty to communicate with the user, it works only if a
       terminal is available, which is the case if amanda is executed from a command line.

       When promted for a volume, the user must put the requested volume in the changer and type
       <enter>. User can type the name of another changer if the volume is available in that
       changer. Typing 'abort' will abort the operation.

   EMAIL
       The email interactivity module uses email to send requests to the user, and reads replies
       from the filesystem.

       The email module has many properties:

       check-file

           If set, amanda will check this file for user input.  The user can touch the file to
           tell amanda that the requested volume was inserted in the changer.  If the user writes
           the name of a changer into the file, Amanda will use that changer.  If the user writes
           the word 'abort' into the file, the scan will be aborted.

       check-file-delay

           Default: 10. This integer property indicates the time in seconds between each check of
           the check-file.

       mailto

           Default: global value of mailto.  The email addresses to which the email should be
           sent.  If multiple addresses are given, they should be separated by spaces.

       resend-delay

           Default 0. The time in seconds between emails.  Amanda will resend the same email at
           this frequency, which can be useful if mailto is a pager or phone.  If set to 0, only
           one email is sent.

   TTY_EMAIL
       The tty_email interactivity module uses the tty module if a terminal is available and uses
       the email module otherwise. Its properties are a combination of properties from each
       module.

EXAMPLE

         define interactivity "by-tty-or-email" {
           comment "Send email on runs from cron; use terminal on command line"
           plugin "tty_email"
           property "mailto" "admin1" "admin2" "me@home"
           property "resend-delay" "1800"               #every 30 minutes
           property "check-file" "/tmp/email_input"
           property "check-file-delay" "10"             #every 10 seconds
         }

SEE ALSO

       amanda(8), amanda.conf(5)

       The Amanda Wiki: : http://wiki.zmanda.com/

AUTHOR

       Jean-Louis Martineau <martineau@zmanda.com>
           Zmanda, Inc. (http://www.zmanda.com)