Provided by: freebsd-manpages_11.1-3_all bug

NAME

     malo — Marvell Libertas IEEE 802.11b/g wireless network driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your kernel
     configuration file:

           device malo
           device pci
           device wlan
           device firmware

     Alternatively, to load the driver as a module at boot time, place the following line in
     loader.conf(5):

           if_malo_load="YES"

DESCRIPTION

     The malo driver provides support for Marvell Libertas 88W8335 based PCI and Cardbus network
     adapters.  malo supports station and monitor mode operation.  Only one virtual interface may
     be configured at any time.  For more information on configuring this device, see
     ifconfig(8).

     This driver requires firmware to be loaded before it will work.  The
     ports/net/malo-firmware-kmod port needs to be installed before ifconfig(8) will work.

HARDWARE

     The following cards are among those supported by the malo driver:

     Card               Chip       Bus    Standard
     Netgear WG311v3    88W8335    PCI    b/g
     Tenda TWL542P      88W8335    PCI    b/g
     U-Khan UW-2054i    88W8335    PCI    b/g

EXAMPLES

     Join an existing BSS network (i.e., connect to an access point):

           ifconfig wlan create wlandev malo0 inet 192.168.0.20 \
               netmask 0xffffff00

     Join a specific BSS network with network name “my_net”:

           ifconfig wlan create wlandev malo0 ssid my_net up

     Join a specific BSS network with 64-bit WEP encryption:

           ifconfig wlan create wlandev malo0 ssid my_net \
                   wepmode on wepkey 0x1234567890 weptxkey 1 up

SEE ALSO

     cardbus(4), pci(4), wlan(4), wlan_ccmp(4), wlan_tkip(4), wlan_wep(4), ifconfig(8),
     wpa_supplicant(8)

HISTORY

     The malo device driver first appeared in FreeBSD 7.1.