Provided by: freebsd-manpages_11.1-3_all bug

NAME

     uhid — USB generic HID support

SYNOPSIS

     To compile this driver into the kernel, place the following line in your kernel
     configuration file:

           device uhid

     Alternatively, to load the driver as a module at boot time, place the following line in
     loader.conf(5):

           uhid_load="YES"

DESCRIPTION

     The uhid driver provides support for all HID (Human Interface Device) interfaces in USB
     devices that do not have a special driver.

     The device handles the following ioctl(2) calls:

     USB_GET_REPORT_ID (int)
             Get the report identifier used by this HID report.

     USB_GET_REPORT_DESC (struct usb_ctl_report_desc)
             Get the HID report descriptor.  Using this descriptor the exact layout and meaning
             of data to/from the device can be found.  The report descriptor is delivered without
             any processing.

             struct usb_ctl_report_desc {
                 int     ucrd_size;
                 u_char  ucrd_data[1024];    /* filled data size will vary */
             };

     USB_SET_IMMED (int)
             Sets the device in a mode where each read(2) will return the current value of the
             input report.  Normally a read(2) will only return the data that the device reports
             on its interrupt pipe.  This call may fail if the device does not support this
             feature.

     USB_GET_REPORT (struct usb_ctl_report)
             Get a report from the device without waiting for data on the interrupt pipe.  The
             report field indicates which report is requested.  It should be UHID_INPUT_REPORT,
             UHID_OUTPUT_REPORT, or UHID_FEATURE_REPORT.  This call may fail if the device does
             not support this feature.

             struct usb_ctl_report {
                     int ucr_report;
                     u_char  ucr_data[1024]; /* used data size will vary */
             };

     USB_SET_REPORT (struct usb_ctl_report)
             Set a report in the device.  The report field indicates which report is to be set.
             It should be UHID_INPUT_REPORT, UHID_OUTPUT_REPORT, or UHID_FEATURE_REPORT.  This
             call may fail if the device does not support this feature.

     Use read(2) to get data from the device.  Data should be read in chunks of the size
     prescribed by the report descriptor.

     Use write(2) to send data to the device.  Data should be written in chunks of the size
     prescribed by the report descriptor.

FILES

     /dev/uhid?

SEE ALSO

     usbhidctl(1), usb(4)

HISTORY

     The uhid driver appeared in NetBSD 1.4.  This manual page was adopted from NetBSD by Tom
     Rhodes <trhodes@FreeBSD.org> in April 2002.