Provided by: libsane_1.0.17-1ubuntu4_i386 bug


       sane-net - SANE network backend


       The  sane-net  library  implements  a  SANE  (Scanner  Access Now Easy)
       backend that provides access to image  acquisition  devices  through  a
       network connection.  This makes it possible to control devices attached
       to a remote host and also provides a means to  grant  users  access  to
       protected resources.


       This backend expects device names of the form:


       Where host is the name (or IP address) of the (remote-) host and device
       is the name of the device on this host that should  be  addressed.   If
       the device name does not contain a colon (:), then the entire string is
       treated as the device string for the default host.  The default host is
       the host listed last in the configuration file (see below).

       An IPv6 address can be specified enclosed in square brackets:



       The  contents  of  the  net.conf  file  is  a list of host names (or IP
       addresses) that should be contacted for scan requests.  Empty lines and
       lines  starting  with  a  hash  mark  (#)  are ignored.  Note that IPv6
       addresses in this file do not need to be enclosed in  square  brackets.
       A sample configuration file is shown below:

              # this is a comment

       The  above  list of hosts can be extended at run-time using environment
       variable  SANE_NET_HOSTS.   This  environment  variable  is  a   colon-
       separated list of hostnames or IP addresses that should be contacted in
       addition to  the  hosts  mentioned  in  the  configuration  file.   For
       example, a user could set the environment variable to the string:


       To  request  that  hosts  ,  [::1]  , and are contacted in addition to the hosts listed above.

       For this backend to function properly, it is also necessary  to  define
       the  sane-port  service  in  /etc/services.  The sane service should be
       defined using a line of the following form:

              sane-port 6566/tcp # SANE network scanner daemon


              The  backend  configuration  file  (see  also   description   of
              SANE_CONFIG_DIR below).

              The static library implementing this backend.

              The shared library implementing this backend (present on systems
              that support dynamic loading).


              This environment variable specifies the list of directories that
              may contain the configuration file.  Under UNIX, the directories
              are separated by a colon (‘:’), under OS/2, they  are  separated
              by  a  semi-colon  (‘;’).   If  this  variable  is  not set, the
              configuration file  is  searched  in  two  default  directories:
              first,   the   current  working  directory  (".")  and  then  in
              /etc/sane.d.  If the value of the environment variable ends with
              the  directory separator character, then the default directories
              are searched after the explicitly  specified  directories.   For
              example,  setting SANE_CONFIG_DIR to "/tmp/config:" would result
              in  directories  "tmp/config",  ".",  and  "/etc/sane.d"   being
              searched (in this order).

              A  colon-separated  list  of  host  names  or IP addresses to be
              contacted by this backend.

              If the library was compiled with  debug  support  enabled,  this
              environment  variable controls the debug level for this backend.
              E.g., a value of 128 requests all debug output  to  be  printed.
              Smaller levels reduce verbosity.


       If  saned  has  timed  out, the net backend may loop with authorization


       sane(7), saned(8), sane-dll(5), scanimage(1)


       David Mosberger and Andreas Beck