
add_txrx - add two new Data Sources called ’tx’ and ’rx’ to an RRD file
add_txrx <file> ...
This utility is used when upgrading from FlowScan-1.005 (or less) to
FlowScan-1.006 (or greater). It is used to add two new Data Sources to
FlowScan ".rrd" files. e.g.:
$ make install # install FlowScan-1.006 in your existing FlowScan dir
$ cd $prefix/graphs
$ add_txrx total.rrd *.*.*.*_*.rrd
tx - a count of the unique source IP addresses
that have transmitted flows
rx - a count of the unique destination IP addresses
that have received flows
These Data Sources will allows FlowScan users to calculate the average
number of bytes, packets, and flows per host and to determine the
overall level of activity (in terms of numbers of individual hosts) for
each subnet and for the entire campus.
The values will be recorded only if you use the TopN directive with the
CampusIO and/or SubNetIO reports. TopN was introduced in
FlowScan-1.006.
For instance, if you set CampusIO’s TopN to a value greater than zero,
the tx value in FlowScan’s "total.rrd" is the number of unique source
IP addresses (hosts) from which FlowScan has seen outbound flows.
Upgrading your RRD Files
If you are upgrading, it is necessary to add two new Data Sources to
the some of your existing RRD files. Before running flowscan, backup
your RRD files, e.g.:
$ cd $prefix/graphs
$ tar cf saved_rrd_files.tar *.rrd
then do this:
$ cd $prefix/graphs
$ ../bin/add_txrx total.rrd [1-9]*.*.*.*_*.rrd
add_ds.pl(1), event2vrule(1), flowscan(1), ip2hostname(1), locker(1)
This manual page was written by Anibal Monsalve Salazar, for the Debian
Project.
ADD_TXRX(1)
Powered by the Ubuntu Manpage Repository generator
Maintained by Dustin Kirkland