Provided by: manpages-dev_2.17-1_all
killpg - send signal to a process group
int killpg(int pgrp, int sig);
Killpg sends the signal sig to the process group pgrp. See signal(7)
for a list of signals. If pgrp is 0, killpg() sends the signal to the
sending process’s process group.
(POSIX says: If pgrp is less than or equal to 1, the behaviour is
For a process to have permission to send a signal it must either be
privileged (under Linux: have the CAP_KILL capability), or the real or
effective user ID of the sending process must equal the real or saved
set-user-ID of the target process. In the case of SIGCONT it suffices
when the sending and receiving processes belong to the same session.
On success, zero is returned. On error, -1 is returned, and errno is
EINVAL Sig is not a valid signal number.
EPERM The process does not have permission to send the signal to any
of the target processes.
ESRCH No process can be found in the process group specified by pgrp.
ESRCH The process group was given as 0 but the sending process does
not have a process group.
There are various differences between the permission checking in BSD-
type systems and SYSV-type systems. See the POSIX rationale for kill().
A difference not mentioned by POSIX concerns the return value EPERM:
BSD documents that no signal is sent and EPERM returned when the
permission check failed for at least one target process, while POSIX
documents EPERM only when the permission check failed for all target
SVr4, 4.4BSD (The killpg() function call first appeared in 4.0BSD).
getpgrp(2), kill(2), signal(2), capabilities(7)