Provided by: pcmcia-cs_3.2.8-5.2ubuntu5_i386
smc91c92_cs - SMC 91cxx device driver
insmod smc91c92_cs.o [pc_debug=n] [if_port=n] [irq_list=i,j,...]
Smc91c92_cs is the low-level Card Services driver for SMC 91c92, 91c94,
91c96, and 91c100 based PC Card ethernet adapters. When this driver is
attached to a card, it allocates the next available ethernet device
(eth0..eth#). This device name will be reported in the kernel log
file, and passed on to cardmgr(8).
With the default transceiver setting, the driver will attempt to
continuously autodetect the transceiver type (10base2 or 10baseT).
There should normally only be a one or two second lag before the
correct transceiver is selected. On particularly noisy or busy
networks, it is possible for the detection logic to incorrectly toggle
the transceiver type. If this becomes a problem, it may be necessary
to explicitly select the interface type when the module is loaded or
with the ifport command.
Selects the PCMCIA debugging level. This parameter is only
available if the module is compiled with debugging enabled. A
non-zero value enables debugging.
Selects the transceiver type. 0 is autodetect (10baseT or
10base2), 1 is 10baseT (twisted pair), and 2 is 10base2 (BNC, or
thin net). The default is 0 (autodetect).
Specifies the set of interrupts that may be allocated by this
eth#: interrupt(s) dropped!
Indicates that the driver did not receive an interrupt
notification for some reason. The driver will poll the card
(with a significant performance penalty) if the problem
persists. The most likely cause is an interrupt conflict and/or
host bridge configuration problem.
David Hinds - firstname.lastname@example.org
cardmgr(8), pcmcia(5), ifport(8).