Provided by: srecord_1.23-1_i386
srec_needham - Needham EMP-series programmer ASCII file format
This format is understood by Needham Electronics’ EMP-series
programmers. See www.needhams.com/winman.pdf for more information.
(This format is very similar to the ASCII-Hex format, but without the
^B and ^C guard characters.)
Each data byte is represented as 2 hexadecimal characters, and is
separated by white space from all other data bytes.
The address for data bytes is set by using a sequence of $Annnn,
characters, where nnnn is the 8-character ascii representation of the
address. The comma is required. There is no need for an address
record unless there are gaps. Implicitly, the file starts a address 0
if no address is set before the first data byte.
In general, binary data will expand in sized by approximately 3.0 times
when represented with this format.
Here is an example ascii-hex file. It contains the data ‘‘Hello,
World’’ to be loaded at address 0x1000.
48 65 6C 6C 6F 2C 20 57 6F 72 6C 64 0A
srec_cat version 1.23
Copyright (C) 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005 Peter
All rights reserved.
The srec_cat program comes with ABSOLUTELY NO WARRANTY; for details use
the ’srec_cat -VERSion License’ command. This is free software and you
are welcome to redistribute it under certain conditions; for details
use the ’srec_cat -VERSion License’ command.
Peter Miller E-Mail: email@example.com
/\/\* WWW: http://www.canb.auug.org.au/~millerp/