Provided by: nictools-nopci_1.3.3-1_i386 bug

NAME

       3c5x9setup - setup program for the 3Com 3x9 cards.

SYNOPSIS

       3c5x9setup [options]

DESCRIPTION

       3c5x9setup  is  a  program  that you can use to setup 3Com 3c5x9 series
       ethercards.

OPTIONS

       These programs follow the usual GNU  command  line  syntax,  with  long
       options  starting  with  two  dashes  (‘-’).   A  summary of options is
       included below.

       -h, --help
              Show summary of options.

       -v, --version
              Show version of program.

       -V, --verbose
              Verbose mode

       -D, --debug
              Show Debug messages

       -a, --all
              Print all registers

       -p, --base-address <port>
              Specify port to use

       -E, --emergency-rewrite
              Re-write a corrupted EEPROM

       -f, --force-detection
              Force if card is busy

       -F, --new-interface <type>
              Interface type to be used. This can be 10baseT, 10base2 or  AUI.

       -P, --new-IOaddress, --new-base-address <port>
              New base I/O address

       -H, --new-hwaddress <addr>
              New base hardware address

       -Q, --new-irq <irq>
              Specify interrupt number

       -w, --write-EEPROM <values>
              Write to the EEPROMS with the specified values.

SEE ALSO

       el3diag(8),

AUTHOR

       This manual page was written by Alain Schroeder <alain@debian.org>, for
       the Debian GNU/Linux system (but may be used by others).

                               January  8, 2001                  3C5X9SETUP(8)