Provided by: nictools-nopci_1.3.3-1_i386 bug

NAME

       al1700-diag - Diagnostic program for the Allied Telesis AT1700

SYNOPSIS

       al1700-diag [options]

DESCRIPTION

       al1700-diag  is a diagnostic program for the Allied Telesis AT1700, and
       similar boards built around the Fujitsu  MB86965.   It  does  not  test
       every   possible   hardware   fault,  but  it  does  verify  the  basic
       functionality ofthe board.

OPTIONS

       These programs follow the usual GNU  command  line  syntax,  with  long
       options  starting  with  two  dashes  (‘-’).   A  summary of options is
       included below.

       -h, --help
              Show summary of options.

       -V, --version
              Show version of program.

       -v, --verbose
              Verbose mode.

       -q, --quiet
              Be very unverbose.

       -a, --all
              Print all registers.

       -e, --show-eeprom
              Dump EEPROM contents to stdout.

       -p, --base-address <port>
              Specify port to use.

       -F, --new-interface <interface>
              Interface  number.  Options  that  make  sense   are:   10baseT,
              100baseTx,  10baseT-FDX,  100baseTx-FDX,  100baseT4,  100baseFx,
              100baseFx-FDX, MII and Autosense.

       -P <address>
              Set card to a new IO base address.

       -Q <irq>
              Set card to a new IRQ.

       -m, --show-mii
              Dump MII management registers.

       -r, --reset-ASIC
              Reset the ASIC.

       -m     Tests multicast.

       -w, --write-EEPROM <values>
              Write to the EEPROMS with the specified values. Do not use this,
              if you do not know what you do!

SEE ALSO

       mii-diag(8)

AUTHOR

       This manual page was written by Alain Schroeder <alain@debian.org>, for
       the Debian GNU/Linux system (but may be used by others).

                               February 23, 2001                AL1700-DIAG(8)