Provided by: mopd_2.5.3-10_i386
mopd - MOP Loader Daemon
mopd [-adf] [interface]
Mopd services MOP Load requests on the Ethernet connected to interface or
all interfaces if ‘-a’ is given. In a load request received by mopd a
filename can be given. This is the normal case for e.g. terminal servers.
If a filename isn’t given mopd must know what image to load.
Upon receiving a request, mopd checks if the requested file exists in
/tftpboot/mop, the filename is normally uppercase and with an extension
of .SYS. If the filename isn’t given, the ethernet address (in lower
case, apart from the .SYS) of the target is used as the filename, e.g.
08002b09f4de.SYS and it might be a soft link to another file.
Mopd supports two kinds of files. The first type that is check is if the
file is in a.out(5) format. If not, a couple of Digital’s formats are
In normal operation, mopd forks a copy of itself and runs in the
background. Anomalies and errors are reported via syslog(3).
-a Listen on all the Ethernets attached to the system. If ‘-a’ is
omitted, an interface must be specified.
-d Run in debug mode, with all the output to stdout. The process
will run in the foreground.
-f Run in the foreground.
a.out(5) isn’t supported yet non bsd implementations (otherOS).
bpf(4), mopa.out(1), mopchk(1), mopprobe(1), moptrace(1)
DECnet Digital Network Architecture Phase IV, Maintenance Operations
Functional Specification V3.0.0, AA-X436A-TK.
DECnet Digital Network Architecture, Maintenance Operations Protocol
Functional Specification V4.0.0, EK-DNA11-FS-001.
Mats O Jansson (firstname.lastname@example.org).