Provided by: nictools-nopci_1.3.3-1_i386 bug

NAME

       ne2k-diag - Diagnostic program for NE2000 ethernet cards.

SYNOPSIS

       ne2k-diag [options]

DESCRIPTION

       ne2k-diag  is used to diagnose detection ("probe") problems with NE1000
       and NE2000 work-alike cards. The probe routine is very similar to  that
       used in the Linux NE2000 driver, and should work with any NE2000 clone.

OPTIONS

       These programs follow the usual GNU  command  line  syntax,  with  long
       options  starting  with  two  dashes  (‘-’).   A  summary of options is
       included below.

       -h, --help
              Show summary of options.

       -V, --version
              Show version of program.

       -v, --verbose
              Verbose mode.

       -D     Debug mode.

       -a, --show-registers
              show chip status (use -aa for even more)

       -e, --show-eeprom
              Dump EEPROM contents to stdout. (use -ee for even more)

       -F, -X, --interface
              Valid values are 0-3.

       -p, --base-address <port>
              Specify port to use.

       -P, --new-address <address>
              Set card to a new hardware address.

       -Q, --new-irq <irq>
              Set card to a new irq. Valid values are 2-5,7,9-15

       -w     Really write to EEPROM.

SEE ALSO

       mii-diag(8)

AUTHOR

       This manual page was written by Alain Schroeder <alain@debian.org>, for
       the Debian GNU/Linux system (but may be used by others).

                                 March 8, 2001                    NE2K-DIAG(8)