Provided by: nictools-pci_1.3.7-2_i386
pcnet-diag - EEPROM setup and diagnostic program for ethernet cards
based on the AMD PCnet/PCI series chips.
pcnet-diag is a program that you can use to diagnose problems with
ethernet cards based on the National Semiconductor DP83820 chip series.
These programs follow the usual GNU command line syntax, with long
options starting with two dashes (‘-’). A summary of options is
Show summary of options.
Show version of program.
Be very unverbose.
Use card number <cardnum>.
Print all registers.
Dump EEPROM contents to stdout.
Re-write a corrupted EEPROM.
-p, --base-address <port>
Specify port to use.
-A, --Advertise <mediaype>
Advertise media type. Valid Options are: 10baseT, 100baseT4,
100baseTx, 100baseTx-FD, 100baseTx-HD, 10baseT-FD and 10baseHD.
-F, --new-interface <interface>
Interface number. Options that make sense are: 10baseT, 10base2,
AUI, 100baseTx, 10baseT-FDX, 100baseTx-FDX, 100baseT4,
100baseFx, 100baseFx-FDX, HomePNA, MII and Autosense.
-H, --new-hwaddress <address>
Set card to a new hardware address.
Dump MII management registers.
Reset the transceiver.
Do register and SRAM test.
-w, --write-EEPROM <values>
Write to the EEPROMS with the specified values. Do not use this,
if you do not know what you do!
Try to identify the card, even if it is active.
-t, --chip-type <card>
Explicitly set the chip. To get all valid numbers, run pcnet-
diag with the options ’-t -1’.
pcnet-diag was written and is still maintained by Donald Becker
<email@example.com>. This manual page was written by Alain Schroeder
<firstname.lastname@example.org>, for the Debian GNU/Linux system (but may be used by
February 18, 2002 PCNET-DIAG(8)