Provided by: sg3-utils_1.17-2_i386 bug

NAME

       sg_rtpg - report target port groups

SYNOPSIS

       sg_rtpg    [--decode]    [--help]   [--hex]   [--verbose]   [--version]
       <scsi_device>

DESCRIPTION

       Send a REPORT TARGET PORT GROUPS SCSI command to the given  device  and
       outputs the response.

       Target  port group access is described in SPC-3 found at www.t10.org in
       section 5.8 (in rev 21c dated 2005/1/15). The Report Target Port Groups
       command is also described in that document.

       --decode | -d
              decodes  the  status  code and asymmetric access state from each
              target port group descriptor returned. The default action is not
              to decode these values.

       --help | -h
              output the usage message then exit.

       --hex | -H
              output  response  in  hex (rather than partially or fully decode
              it).

       --verbose | -v
              increase the level of verbosity, (i.e. debug output).

       --version | -V
              print the version string and then exit.

       The Report Target Port Groups command should be supported whenever  the
       TPGS  bits  in a standard INQUIRY response are greater than zero. [View
       with sg_inq utility.]

AUTHORS

       Written by Douglas Gilbert.

REPORTING BUGS

       Report bugs to <dgilbert at interlog dot com>.

COPYRIGHT

       Copyright © 2004-2005 Christophe Varoqui and Douglas Gilbert
       This software is distributed under  a  FreeBSD  license.  There  is  NO
       warranty;  not  even  for  MERCHANTABILITY  or FITNESS FOR A PARTICULAR
       PURPOSE.

SEE ALSO

       sg_inq(sg3_utils)