Provided by: nictools-pci_1.3.7-2_i386 bug

NAME

       winbond-diag  - EEPROM setup and diagnostic program for Winbond w89c840
       based Ethernet cards.

SYNOPSIS

       winbond-diag [options]

DESCRIPTION

       winbond-diag is a program that you can use to  diagnose  problems  with
       Ethernet cards based on the Winbond w89c840 chip.

OPTIONS

       These  programs  follow  the  usual  GNU command line syntax, with long
       options starting with two  dashes  (‘-’).   A  summary  of  options  is
       included below.

       -h, --help
              Show summary of options.

       -V, --version
              Show version of program.

       -v, --verbose
              Verbose mode.

       -q, --quiet
              Be very unverbose.

       -# <cardnum>
              Use card number <cardnum>.

       -a, --show_all_registers
              Print all registers.

       -e, --show-eeprom
              Dump EEPROM contents to stdout.

       -E, --emergency-rewrite
              Re-write a corrupted EEPROM.

       -p, --base-address <port>
              Specify port to use.

       -A, --Advertise <mediaype>
              Advertise  media  type.  Valid  Options are: 10baseT, 100baseT4,
              100baseTx, 100baseTx-FD, 100baseTx-HD, 10baseT-FD and  10baseHD.

       -F, --new-interface <interface>
              Interface number. Options that make sense are: 10baseT, 10base2,
              AUI,   100baseTx,   10baseT-FDX,    100baseTx-FDX,    100baseT4,
              100baseFx, 100baseFx-FDX, MII and Autosense.

       -H, --new-hwaddress <address>
              Set card to a new hardware address.

       -m, --show-mii
              Dump MII management registers.

       -R, --reset
              Reset the transceiver.

       -T, --test
              Do register and SRAM test.

       -w, --write-EEPROM <values>
              Write to the EEPROMS with the specified values. Do not use this,
              if you do not know what you do!

       -f, --force-detection
              Try to identify the card, even if it is active.

       -t, --chip-type <card>
              Explicitly set the chip. To get all valid numbers, run  winbond-
              diag with the options ’-t -1’.

SEE ALSO

       mii-diag(8)

AUTHOR

       winbond-diag  was  written  and  is  still  maintained by Donald Becker
       <becker@scyld.com>.  This manual page was written  by  Alain  Schroeder
       <alain@debian.org>, for the Debian GNU/Linux system (but may be used by
       others).

                               February 18, 2002               WINBOND-DIAG(8)