Provided by: trace-cmd_2.6.1-0.1_amd64
trace-cmd-split - split a trace.dat file into smaller files
trace-cmd split [OPTIONS] [start-time [end-time]]
The trace-cmd(1) split is used to break up a trace.dat into small files. The start-time specifies where the new file will start at. Using trace-cmd-report(1) and copying the time stamp given at a particular event, can be used as input for either start-time or end-time. The split will stop creating files when it reaches an event after end-time. If only the end-time is needed, use 0.0 as the start-time. If start-time is left out, then the split will start at the beginning of the file. If end-time is left out, then split will continue to the end unless it meets one of the requirements specified by the options.
-i file If this option is not specified, then the split command will look for the file named trace.dat. This options will allow the reading of another file other than trace.dat. -o file By default, the split command will use the input file name as a basis of where to write the split files. The output file will be the input file with an attached '.#\' to the end: trace.dat.1, trace.dat.2, etc. This option will change the name of the base file used. -o file will create file.1, file.2, etc. -s seconds This specifies how many seconds should be recorded before the new file should stop. -m milliseconds This specifies how many milliseconds should be recorded before the new file should stop. -u microseconds This specifies how many microseconds should be recorded before the new file should stop. -e events This specifies how many events should be recorded before the new file should stop. -p pages This specifies the number of pages that should be recorded before the new file should stop. Note: only one of *-p*, *-e*, *-u*, *-m*, *-s* may be specified at a time. If *-p* is specified, then *-c* is automatically set. -r This option causes the break up to repeat until end-time is reached (or end of the input if end-time is not specified). trace-cmd split -r -e 10000 This will break up trace.dat into several smaller files, each with at most 10,000 events in it. -c This option causes the above break up to be per CPU. trace-cmd split -c -p 10 This will create a file that has 10 pages per each CPU from the input. -C cpu This option will split for a single CPU. Only the cpu named will be extracted from the file. trace-cmd split -C 1 This will split out all the events for cpu 1 in the file.
trace-cmd(1), trace-cmd-record(1), trace-cmd-report(1), trace-cmd-start(1), trace-cmd-stop(1), trace-cmd-extract(1), trace-cmd-reset(1), trace-cmd-list(1), trace-cmd-listen(1)
Written by Steven Rostedt, <firstname.lastname@example.org>
Copyright (C) 2010 Red Hat, Inc. Free use of this software is granted under the terms of the GNU Public License (GPL).
1. email@example.com mailto:firstname.lastname@example.org 09/12/2017 TRACE-CMD-SPLIT(1)