Provided by: amanda-common_3.5.1-2build2_amd64 bug


       amlabel - label an Amanda tape


       amlabel [--barcode barcode] [--meta meta-label] [--pool pool] [--storage storage]
               [--assign] [-f] [--version] [-o configoption...] config [label] [slot slot]


       This command applies a label to an Amanda volume, erasing the volume in the process.

       Amanda uses labels to identify volumes: amdump(8) and amflush(8) verify the label before
       writing to make sure the proper volume is loaded, and the recovery programs use the label
       to ensure they are reading the data they expect.

       If no [slot] and no [barcode] is given, then amlabel labels the tape in the current slot
       of the default changer. If a slot is given, it labels the volume in that slot. If a
       barcode is given, it labels the volume with that barcode.  Label may be any string that
       does not contain whitespace and that matches the labelstr (see amanda.conf(5)).

       If [label] is not given, an autolabel is generated, see autolabel in amanda.conf(5).

       If [--assign] is given, the label is interpretad as an expression and the barcode,
       meta-label, pool, storage and config are assigned to all labels matching the expression,
       the volumes are not labelled. The labels must already be in the tapelist file.

       This command also appends the new volume to the tapelist(5) file, so that they will be
       used in the order they are labeled (depending on the taperscan in use — see amanda-

       As a precaution, amlabel will not write a label if the volume already contains an active
       label or if the label specified is on an active tape. The [-f] (force) flag bypasses these


       --barcode barcode
           With [--assign], assign the barcode to the label. Without [--assign], label the volume
           with that barcode.

       --meta meta-label
           Assign the meta label to the label after labeling the volume.

       --pool pool
           Assign the pool to the label after labeling the volume.

       --storage storage
           Assign the storage to the label, it can only be used with --assign, you can't assign a
           storage to a new labelled volume.

           Assign the barcode or meta-label to the label without labeling the volume. The label
           must already be in the tapelist file.

           Force the label operation; see above

           Output version information

       -o configoption
           See the "CONFIGURATION OVERRIDE" section in amanda(8).


       Write an Amanda label with the string "DMP000" on the current volume:
       % amlabel daily DMP000

       Label the tape in slot 3 of the changer with the label "DMP003":
       % amlabel daily DMP003 slot 3


       Label 'label' doesn't match labelstr 'labelstr'
           The given label does not match the configured labelstr. Even with -f, this is an

       Label 'label' already on a volume
           The given label is already on another volume in the tapelist, and Amanda will not
           write it to this volume unless forced.

       Found label 'label', but it is not from configuration config.
           The label amlabel found on the volume does not match this configuration's labelstr, so
           it is probably part of a different Amanda configuration. Amanda will not overwrite the
           label unless it is forced.

       Volume with label 'label' contains data from this configuration.
           The label amlabel found on the volume still has valid data on it and Amanda will not
           overwrite it unless forced. Note that this does not distinguish between active and
           inactive volumes.


       amanda(8), amanda.conf(5), tapelist(5), amanda-taperscan(7), amdump(8), amflush(8)

       The Amanda Wiki: :


       James da Silva <>

       Stefan G. Weichinger <>

       Dustin J. Mitchell <>
           Zmanda, Inc. (