Provided by: smp-utils_0.98-2build1_amd64
smp_rep_broadcast - invoke REPORT BROADCAST SMP function
smp_rep_broadcast [--broadcast=BT] [--help] [--hex] [--interface=PARAMS] [--raw] [--sa=SAS_ADDR] [--verbose] [--version] SMP_DEVICE[,N]
Sends a SAS Serial Management Protocol (SMP) REPORT BROADCAST function request to an SMP target. The SMP target is identified by the SMP_DEVICE and the --sa=SAS_ADDR. Depending on the interface, the SAS_ADDR may be deduced from the SMP_DEVICE. The mpt interface uses SMP_DEVICE to identify a HBA (an SMP initiator) and needs the additional ,N to differentiate between HBAs if there are multiple present.
Mandatory arguments to long options are mandatory for short options as well. -b, --broadcast=BT BT is the broadcast type, an integer in the range 0 (default) to 15. Broadcast (Change) corresponds to 0. Other known broadcast types are listed in the NOTES section. BT may be decimal (default) or hexadecimal prefixed by '0x' (or '0X') or with a 'h' (or 'H') suffix. -h, --help output the usage message then exit. -H, --hex output the response (less the CRC field) in hexadecimal. -I, --interface=PARAMS interface specific parameters. In this case "interface" refers to the path through the operating system to the SMP initiator. See the smp_utils man page for more information. -r, --raw send the response (less the CRC field) to stdout in binary. All error messages are sent to stderr. -s, --sa=SAS_ADDR specifies the SAS address of the SMP target device. The mpt interface needs this option and it will typically be an expander's SAS address. The SAS_ADDR is in decimal but most SAS addresses are shown in hexadecimal. To give a number in hexadecimal either prefix it with '0x' or put a trailing 'h' on it. -v, --verbose increase the verbosity of the output. Can be used multiple times. -V, --version print the version string and then exit.
The following is a list of broadcast types: 0 Broadcast (Change) 1 Broadcast (Reserved change 0) 2 Broadcast (Reserved change 1) 3 Broadcast (SES) 4 Broadcast (Expander) 5 Broadcast (Asynchronous event) 6 Broadcast (Reserved 3) 7 Broadcast (Reserved 4) 8 Broadcast (Zone activate) The remaining zone types (9 to 15) may be issued by the ZONED BROADCAST function.
The SMP REPORT BROADCAST function was introduced in SAS-2 .
Written by Douglas Gilbert.
Report bugs to <dgilbert at interlog dot com>.
Copyright © 2011-2012 Douglas Gilbert This software is distributed under a FreeBSD license. There is NO warranty; not even for MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.