Provided by: istgt_0.4~20111008-3build1_amd64
istgtcontrol - istgt iSCSI target command utility
istgtcontrol [options] <command> [<file>]
istgtcontrol is a command and control utility for istgt(1). It can be used to query and change the status of a local or remote istgt instance. istgtcontrol supports the commands denoted below to interact with the istgt instance. By default it connects and authenticates to the iSCSI target portal specified in the istgtcontrol.conf configuration file and uses CHAP credentials denoted there, if any. Both can be overridden by using the respecitve command line arguments.
istgtcontrol understands the following commands which can be forwarded to istgt: noop Do not actually do anything, but test responsiveness of the portal and test CHAP credentials only. version Retrieve the istgt version number providing the iSCSI portal istgtcontrol connected to. list List all, or the specified targets only, which shared by the portal. load Load a new media to the specified unit. This command issues the same command as if a drive tray had been closed on a SCSI device. unload Unload a media from the specified unit. This command issues the same command as if the drive tray had been opened from a SCSI device. change file Change the loaded media by the specified unit. This command is equivalent as if a new media (for example a DVD-ROM or tape cartridge) had been inserted in the SCSI drive. The "file" argument is interpreted as filename to be loaded. reset Reset the specified LUN of the portal. info Display all connections of the portal
-c config Use specified file as configuration file instead of the default file. -h host Override the target portal by the specified host name or IP address. This defaults to "localhost" if no other host was specified in the configuration file. -p port Override the target portal port by the specified port number. This defaults to "3261" if no other port was specified in the configuration file. -t target Specifies the target IQN which should be affected by the command given. There may be a default given in the configuration file. The keyword "all" is accepted by some commands and matches all exported volumes. -l lun Specifies the target LUN which should be affected by the command given. This defaults to "0" unless another default was provided in the configuration file. -f flags Specifies flags passed to the portal when loading a new media. This defaults to "ro". Supported flags are: "ro", "rw", "extend" and "dynamic". -s size Specifies the size of the meda to be loaded. The default is to auto-detect the media size. -q Quiet mode, supress non-critical outputs. -v Verbose mode, gives more output during operations. -A method Sets the preferred authentication method for logging in to the portal. This overrides any method specified in the configuration file. Supported methods are either CHAP/Mutual or CHAP/Auto. -U user Sets the user to authenticate on the portal. This overrides any username specified in the configuration file. -S secret Set the secret used to authenticate on the portal. This overrides any secret specified in the configuration file. -M muser Set the mutual authentication user. This overrides any user specified in the configuration file. -R msecret Set the mutual authentication secret. This overrides any secret specified in the configuration file. -H Display a brief usage summary and exit. -V Display the istgtcontrol version number and exit. FILES /etc/istgt/istgtcontrol.conf Configuration file
Daisuke Aoyama <firstname.lastname@example.org> This manual page was written by Arno Töll (<email@example.com>) for the Debian GNU/kFreeBSD system (but may be used by others).