Provided by: manpages-dev_2.77-1_all
fallocate - manipulate file space
long fallocate(int fd, int mode, loff_t offset, loff_t len);
fallocate() allows the caller to directly manipulate the allocated disk
space for the file referred to by fd for the byte range starting at
offset and continuing for len bytes.
The mode argument determines the operation to be performed on the given
range. Currently only one flag is supported for mode:
This flag allocates and initializes to zero the disk space
within the range specified by offset and len. After a
successful call, subsequent writes into this range are
guaranteed not to fail because of lack of disk space.
Preallocating zeroed blocks beyond the end of the file is useful
for optimizing append workloads. Preallocating blocks does not
change the file size (as reported by stat(2)) even if it is less
If FALLOC_FL_KEEP_SIZE flag is not specified in mode, the default
behavior is almost same as when this flag is specified. The only
difference is that on success, the file size will be changed if offset
+ len is greater than the file size. This default behavior closely
resembles the behavior of the posix_fallocate(3) library function, and
is intended as a method of optimally implementing that function.
Because allocation is done in block size chunks, fallocate() may
allocate a larger range than that which was specified.
fallocate() returns zero on success, or an error number on failure.
Note that errno is not set.
EBADF fd is not a valid file descriptor, or is not opened for writing.
EFBIG offset+len exceeds the maximum file size.
EINTR A signal was caught during execution.
EINVAL offset was less than 0, or len was less than or equal to 0.
EIO An I/O error occurred while reading from or writing to a file
ENODEV fd does not refer to a regular file or a directory. (If fd is a
pipe or FIFO, a different error results.)
ENOSPC There is not enough space left on the device containing the file
referred to by fd.
ENOSYS The file system containing the file referred to by fd does not
support this operation.
The mode is not supported by the file system containing the file
referred to by fd.
fallocate() is available on Linux since kernel 2.6.23.
fallocate() is Linux-specific.
ftruncate(2), posix_fallocate(3), posix_fadvise(3)
This page is part of release 2.77 of the Linux man-pages project. A
description of the project, and information about reporting bugs, can
be found at http://www.kernel.org/doc/man-pages/.