Provided by: libsane_1.0.19-1ubuntu3_i386
sane-pixma - SANE backend for Canon PIXMA MP series
The sane-pixma library implements a SANE (Scanner Access Now Easy)
backend that provides access to Canon PIXMA multi-function devices
(All-in-one printers). Currently, the following models work with this
PIXMA MP150, MP160, MP170, MP180, MP450, MP460
PIXMA MP500, MP510, MP530, MP600, MP600R
PIXMA MP800, MP800R, MP810, MP830, MP960
MultiPASS MP700, PIXMA MP750 (no grayscale)
The following models are not well tested and/or the scanner sometimes
hangs and must be switched off and on.
SmartBase MP360, MP370, MP390
MultiPASS MP730, PIXMA MP760, PIXMA MP780
The backend supports
* resolutions at 75,150,300,600,1200 and 2400 DPI (still buggy),
* color and grayscale mode,
* a custom gamma table and
* automatic document feeder (only single side).
The device name is in the form pixma:xxxxyyyy_zzzzz where x, y and z
are vendor ID, product ID and serial number respectively. Example:
pixma:04A91709_123456 is a MP150.
This backend is in alpha stage and will stay in this stage until we get
the programming manual for the hardware. Although we have tested it as
good as we could, it will not work in every situations. You will find
an up-to-date status at the project homepage. (See below)
Besides "well-known" options (e.g. resolution, mode etc.) pixma backend
also provides the following experimental options for button handling,
i.e. the options might change in the future.
This option can be used in combination with scanadf(1) and
scanimage(1) in batch mode, for example when you want to scan
many photos or multiple-page documents. If it is enabled (i.e.
is set to true or yes), the backend waits before every scan
until the user presses the "SCAN" button (for MP150) or the
color-scan button (for other models). Just put the first page in
the scanner, press the button, then the next page, press the
button and so on. When you finished, press the gray-scan button.
(For MP150 you have to stop the frontend by pressing Ctrl-C for
button-update button-1 button-2
These options are interesting for developers. To check button
status: (1) set button-1 and button-2 to zero, (2) set button-
update (Its type is SANE_TYPE_BUTTON.), (3) get button-1 and
button-2. If the result is not zero, the corresponding button
The static library implementing this backend.
The shared library implementing this backend (present on systems
that support dynamic loading).
If the library was compiled with debug support enabled, this
environment variable controls the debug level for this backend.
Higher value increases the verbosity.
0 print nothing (default)
1 print error and warning messages (recommended)
2 print informational messages
3 print debug-level messages
10 dump USB traffics
Setting to a non-zero value will enable the support for
experimental models. You should also set SANE_DEBUG_PIXMA to
sane(7), sane-dll(5), http://home.arcor.de/wittawat/pixma/
I would like to thank all testers and helpers. Without them I would not
be able to write subdrivers for models I don’t have. See also the