Provided by: svgalib-bin_1.4.3-24_i386
dumpreg - dump the state of the card as the svgalib chipset driver sees
dumpreg < /dev/ttyN
The chipset drivers of svgalib inquire the mode of the graphic card
when the application is started and restore it when the svgalib
application quits. dumpreg prints this information to stdout.
This is useful for debugging or adding modes to a device driver. For
example you can use Xfree86 to setup a given mode timing, then run
dumpreg and use it’s stdout to make your chipset driver use exactly
However, the recent change of svgalib to hunt an own free virtual
console does not allow this, because it will make Xfree86 return to
textmode first. You can avoid this by using the second form where N is
the number of the virtual console on which Xfree86 runs (usually 7) as
svgalib(7), vgagl(7), libvga.config(5), vga_dumpregs(3), convfont(1),
fix132x43(1), restorefont(1), restorepalette(1), restoretextmode(1),
runx(1), savetextmode(1), setmclk(1), textmode(1).
This manual page was edited by Michael Weller <firstname.lastname@example.org-
essen.de>. The exact source of the referenced utility as well as of the
original documentation is unknown.
It is very likely that both are at least to some extent are due to Harm
Occasionally this might be wrong. I hereby asked to be excused by the
original author and will happily accept any additions or corrections to
this first version of the svgalib manual.