Provided by: freebsd-manpages_6.2-1_all
rc - RISCom/8 multiport card
The RISCom/8 is an eight port ISA RS-232C communications multiplexer with
a built in RISC processor. It uses a block of sixteen I/O ports in the
range 0x200 to 0x3f0 selectable by on-board switches or jumpers. The
block must be aligned on a sixteen port boundary. The jumper-selectable
hardware interrupt level may be set to be detected during system
initialization using settings found in the /boot/device.hints file.
This driver is mostly based on the Cirrus Logic CL-CD180 driver.
The rc driver provides support for the SDL Communications RISCom/8
The following driver specific error messages may be reported:
rc%d channel%d: interrupt-level buffer overflow An internal buffer
overflow error has occurred on the listed channel. The rc driver will
need to be reloaded to correct this.
rc%d: Bad char chan %d The channel has obtained a bad set of characters.
rc%d: Got extra chars chan %d The rc driver got more characters than
expected on the channel shown.
rc%d: data mismatch chan %d ptr %d (%d != %d) Data sent from channel %d
to the rx buffer was different then expected.
rc%d: channel %d command timeout, rc.c line: %d A command timeout has
occurred on the channel, the src/sys/dev/rc/rc.c file can be consulted
for more information.
tty(1), ttyname(3), sio(4), tty(4), device.hints(5), comcontrol(8),
getty(8), mutex(9), splx(9)
The rc driver first appeared in FreeBSD 2.0.5. This manual page first
appeared in FreeBSD 5.3.
This manual page was written by Tom Rhodes 〈trhodes@FreeBSD.org〉.
The rc driver code still uses the spl(9) functions. These should be
replaced by mutex(9) functions.
The various ttyld_*() functions should be documented.