Provided by: cpufreqd_2.2.1-2_i386
cpufreqd - intelligently monitor and manipulate CPU frequency
cpufreqd [-Dmhv] [-f filename] [-V verbosity]
cpufreqd is used to monitor the status of the system and adjust the
frequency of the CPU according to the user configuration. The
behaviour of the daemon is fully configurable. Logs are reported
stay in foreground (used to debug).
start in manual mode.
-f filename, --file=filename
Specify the configuration file to read. The default is
Display command line help.
Display the version number of the daemon.
verbosity level from 0 (less verbose) to 7 (most verbose).
Default verbosity is 4
SIGHUP This lets cpufreqd perform a re-initialization. The
configuration file (default is /etc/cpufreqd.conf) will be re-
read and probes re-done. (Not yet implemented in cpufreqd-2.0)
cpufreqd will terminate.
Some ACPI implementations are very cpu-consuming when reading the info
system batteries. Cpufreqd implements a simple workaround that
avoids reading that file except on initialization or
reinitialization. This has the effect of needing to send an HUP
signal if inserting a new battery, otherwise battery measurement
won’t be correct.
kernel cpu frequency interface
old deprecated kernel cpu frequency interface (please avoid it)
kernel power management interface (ACPI)
kernel power management interface (APM)
kernel power management interface (PMU). (Not yet implemented in
cpufreqd configuration file
Multiple CPUs are not considered separately thus the same policy is set
in every available CPU. Battery can only be specified in percent, not
in minutes remaining.
George Staikos <firstname.lastname@example.org>
Mattia Dongili <email@example.com>
Rene Rebe <firstname.lastname@example.org>
05 May 2005 CPUFREQD(8)