Provided by: freebsd-manpages_7.0-2_all
udbp - USB Double Bulk Pipe driver
To compile this driver into the kernel, place the following line in your
kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
The udbp driver provides support for host-to-host cables that contain at
least two bulk pipes (one for each direction), for example the EzLink
cable and the NetChip 1080 chip.
It requires netgraph(4) to be available. This can be done either by
adding options NETGRAPH to your kernel configuration file, or
alternatively loading netgraph(4) as a module, either from
/boot/loader.conf or from the command line, before the udbp module.
Add the udbp driver to the kernel.
Load the netgraph(4) module and then the udbp driver.
ngctl mkpeer udbp0: iface data inet
ifconfig ng0 10.0.0.1 10.0.0.2
Create a new network interface node and connect its inet hook to the data
hook of the udbp node. ifconfig(8) configures the resulting network
interface ng0 with a local IP address of 10.0.0.1 and a remote IP address
of 10.0.0.2. On the remote host, the two IP addresses should of course
netgraph(4), ng_iface(4), ohci(4), uhci(4), usb(4), ngctl(8)
The udbp driver first appeared in FreeBSD 5.0.
The udbp driver was written by Doug Ambrisko 〈email@example.com〉,
Julian Elischer 〈julian@FreeBSD.org〉 and Nick Hibma
This manual page was written by Nick Hibma 〈n_hibma@FreeBSD.org〉.