Provided by: freebsd-manpages_7.1~beta1-1_all
ufoma - USB mobile phone support
To compile this driver into the kernel, place the following lines in your
kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
The ufoma driver provides support for USB mobile phone terminals in the
subset of the Mobile Computing Promotion Consortium USB Implementation
Guideline, which is adopted by FOMA, the NTT DoCoMo 3G system, terminal.
These are partly like CDC ACM model based modems, which are supported by
umodem(4), but the ufoma driver recognizes a specific USB descriptor that
describes its role and interface structure, and it will negotiate its
role when the device is open. They support a regular AT command set and
the commands can either be multiplexed with the data stream or handled
through separate pipes. In the latter case the AT commands have to be
given on a device separate from the data device.
The device is accessed through the ucom(4) driver which makes it behave
like a tty(4).
These devices often have a few interface sets and these interfaces have
their role, sometimes multiplexed. These roles are identified with the
following sysctl MIBs:
The modes which are supported by the interface.
Current mode of the interface.
Mode to transit when the device is open next.
The modes are as follows:
modem Accepts AT commands and go and pass packet communication data.
Accepts AT commands but it does not pass data.
obex Accepts OBEX frame which is used to exchange telephone book, etc.
Vendor specific data may be passed.
When an interface is recognized by the system but not used, the
interface will be set to this mode.
When an interface is not yet negotiated, the interface is in this
Devices supported by the ufoma driver include:
· SHARP FOMA SH902i
· KYOCERA PHS AH-K3001V (a.k.a Kyopon)
· SANYO Vodafone3G V801SA
Specification can be found at:
tty(4), ucom(4), umodem(4), usb(4)
The ufoma driver appeared in FreeBSD 7.0, partly derived from the
Interfaces with multiplexed commands and data and interfaces with
commands only are supported.