Provided by: libsane_1.0.19-23ubuntu7_i386
sane-sm3840 - SANE backend for Microtek scanners with SCAN08 USB chip
The sane-sm3840 library implements a SANE (Scanner Access Now Easy)
backend that provides access to some Microtek scanners with the SCAN08
There exist backends for Microtek scanners with SCSI command set.
Refer to sane-microtek(5) and sane-microtek2(5) for details.
There also exists a Microtek 3600 series driver, see sane-sm3600(5) for
At present, the following scanners are known positively to work with
Vendor Product ID: Remark:
-------- -------------- -----------
Microtek ScanMaker 3840 All modes OK
Microtek ScanMaker 4800 All modes OK
If you own a Microtek scanner with the SCAN08 chip other than the ones
listed above, it may or may not work with SANE. Feel free to contact
the backend author (email@example.com) to report results with scanners
not on the list.
The following options are supported by the sm3840-driver:
Color or grayscale mode.
Pixels per inch for scans.
Note that the least significant bits of 16bpp mode may be noise.
Higher numbers increase brightness of returned image.
Larger numbers decrease contrast of returned image.
Time in minutes until the lamp is turned off after a scan.
This backend does not support a configuration file right now.
The static library implementing this backend.
The shared library implementing this backend (present on systems
that support dynamic loading).
If the library was compiled with debug support enabled, this
environment variable controls the debug level for this backend.
E.g., a value of 128 requests all debug output to be printed.
Smaller levels reduce verbosity. To see error messages on stderr
set SANE_DEBUG_SM3840 to 1.
sane-microtek2(5), sane-sm3600(5), http://www.ziplabel.com/sm3840
Earle F. Philhower III (firstname.lastname@example.org)