Provided by: wicd_1.5.9-2_all bug

NAME

       wicd-manager-settings.conf  -  contains  settings  that  control Wicd’s
       behavior

DESCRIPTION

       This file contains general configuration information for Wicd.
       This file is located at /etc/wicd/manager-settings.conf

SETTINGS

       link_detect_tool = <0|1|2>
              0 = autodetect
              1 = ethtool
              2 = mii-tool

       flush_tool = <0|1|2>
              0 = autodetect
              1 = ip
              2 = route

       signal_display_type = <0|1>
              0 = Show signal strength as a percentage
              1 = Show signal strength in dBm

       dhcp_client = <0|1|2|3>
              0 = autodetect
              1 = dhclient
              2 = dhcpcd 3 = pump

       wired_interface = <interface_name>

       always_show_wired_interface = <True|False>

       wired_connect_mode = <0|1>
              0 = connect to wired interface automatically
              1 = do not connect to wired interface automatically

       wireless_interface = <name_of_wireless_interface>

       wpa_driver                                                            =
       <wext|madwifi|ndiswrapper|hostap|hermes|atmel|broadcom|ipw|ralinklegacy>
              The default (and  best  supported)  is  wext.   It  should  work
              properly in most cases.

       auto_reconnect = <True|False>
              This  settings determines whether Wicd will attempt to reconnect
              on connection loss.

       use_global_dns = <True|False>
              If set to "True" and values are  specified  in  the  global  DNS
              settings  below, this will cause Wicd to use these DNS settings.

       global_dns_1 = <ip_address>

       global_dns_2 = <ip_address>

       global_dns_3 = <ip_address>

       debug_mode = <integer_value>
              0 = disabled
              1 = enabled

       window_height = <integer_value> (in pixels)
              This determines the height of the client window.

       window_width = <integer_value> (in pixels)
              This determines the width of the client window.

       pref_height = <integer_value> (in pixels)
              This determines the height  of  the  "Preferences"  window  when
              launched from the client.

       pref_width = <integer_value> (in pixels)
              This  determines  the  width  of  the  "Preferences" window when
              launched from the client.

SEE ALSO

       wicd(8), wicd-wired-settings.conf(5), wicd-wireless-settings.conf(5).