Provided by: freebsd-manpages_7.2-1_all
ng_iface - interface netgraph node type
An iface node is both a netgraph node and a system networking interface.
When an iface node is created, a new interface appears which is
accessible via ifconfig(8). Iface node interfaces are named ng0, ng1,
etc. When a node is shutdown, the corresponding interface is removed and
the interface name becomes available for reuse by future iface nodes; new
nodes always take the first unused interface. The node itself is
assigned the same name as its interface, unless the name already exists,
in which case the node remains unnamed.
An iface node has a single hook corresponding to each supported protocol.
Packets transmitted via the interface flow out the corresponding
protocol-specific hook. Similarly, packets received on a hook appear on
the interface as packets received into the corresponding protocol stack.
The currently supported protocols are IP, IPv6, AppleTalk, IPX, ATM,
NATM, and NS.
An iface node can be configured as a point-to-point interface or a
broadcast interface. The configuration can only be changed when the
interface is down. The default mode is point-to-point.
Iface nodes support the Berkeley Packet Filter (BPF).
This node type supports the following hooks:
inet Transmission and reception of IP packets.
inet6 Transmission and reception of IPv6 packets.
atalk Transmission and reception of AppleTalk packets.
ipx Transmission and reception of IPX packets.
atm Transmission and reception of ATM packets.
natm Transmission and reception of NATM packets.
ns Transmission and reception of NS packets.
This node type supports the generic control messages, plus the following:
Returns the name of the associated interface as a NUL-terminated
ASCII string. Normally this is the same as the name of the node.
Returns the global index of the associated interface as a 32 bit
Set the interface to point-to-point mode. The interface must not
currently be up.
Set the interface to broadcast mode. The interface must not
currently be up.
This message is defined by the ng_cisco(4) node type; see
ng_cisco(4) for a description.
This node shuts down upon receipt of a NGM_SHUTDOWN control message. The
associated interface is removed and becomes available for use by future
Unlike most other node types, an iface node does not go away when all
hooks have been disconnected; rather, and explicit NGM_SHUTDOWN control
message is required.
The ng_iface interface supports ALTQ bandwidth management feature.
However, ng_iface is a special case, since it is not a physical interface
with limited bandwidth. One should not turn ALTQ on ng_iface if the
latter corresponds to some tunneled connection, e.g. PPPoE or PPTP. In
this case, ALTQ should be configured on the interface that is used to
transmit the encapsulated packets. In case when your graph ends up with
some kind of serial line, either synchronous or modem, the ng_iface is
the right place to turn ALTQ on.
altq(4), bpf(4), netgraph(4), ng_cisco(4), ifconfig(8), ngctl(8)
The iface node type was implemented in FreeBSD 4.0.
Archie Cobbs 〈archie@FreeBSD.org〉