Provided by: shorewall-common_4.2.10-1_all
netmap - Shorewall NETMAP definition file
This file is used to map addresses in one network to corresponding
addresses in a second network.
To use this file, your kernel and iptables must have NETMAP support
The columns in the file are as follows.
TYPE - DNAT|SNAT
Must be DNAT or SNAT.
If DNAT, traffic entering INTERFACE and addressed to NET1 has it´s
destination address rewritten to the corresponding address in NET2.
If SNAT, traffic leaving INTERFACE with a source address in NET1
has it´s source address rewritten to the corresponding address in
NET1 - network-address
Network in CIDR format (e.g., 192.168.1.0/24).
INTERFACE - interface
The name of a network interface. The interface must be defined in
shorewall-interfaces(5) Prior to Shorewall 4.1.4, this must be
an exact match. Shorewall-perl 4.1.4 and later allow loose matches
to wildcard entries in shorewall-interfaces(5). For example,
ppp0 in this file will match a shorewall-interfaces(8) entry
that defines ppp+.
NET2 - network-address
Network in CIDR format
shorewall(8), shorewall-accounting(5), shorewall-actions(5),
shorewall-blacklist(5), shorewall-hosts(5), shorewall-interfaces(5),
shorewall-ipsec(5), shorewall-maclist(5), shorewall-masq(5),
shorewall-nat(5), shorewall-params(5), shorewall-policy(5),
shorewall-rules(5), shorewall.conf(5), shorewall-tcclasses(5),
shorewall-tcdevices(5), shorewall-tcrules(5), shorewall-tos(5),