Provided by: srecord_1.52-1_i386
srec_ascii_hex - Ascii-Hex file format
This format is also known as the Ascii-Space-Hex or Ascii-Hex-Space
format. If you know who invented this format, please let me know. If
you have a better or more complete description, I’d like to know that,
The file starts with a start-of-text (STX or Control-B) character
(0x02). Everything before the STX is ignored.
Each data byte is represented as 2 hexadecimal characters, followd by
an "execution character". The default execution character is a space,
although many programs which write this format omit the space character
immediately preceeding end-of-line.
The address for data bytes is set by using a sequence of $Annnn,
characters, where nnnn is the 4-character ascii representation of the
address. The comma is required. There is no need for an address
record unless there are gaps. Implicitly, the file starts a address 0
if no address is set before the first data byte.
The file ends with an end-of-text (ETX or Control-C) character (0x03).
Everything following the ETX is ignored.
It is also possible to specify a running 16-bit checksum using a
sequence of $Snnnn, characters, although this usually appears after the
ETX character and is thus often ignored.
In addition to a space character, the execution character can also be
percent (%) called "ascii-hex-percent" format, apostrophe (’) or comma
(,) called "ascii-hex-comma" format. The file must use the same
execution character throughout.
If the execution character is a comma, the address and checksum
commands are terminated by a dot (.) rather than a comma (,).
In general, binary data will expand in sized by approximately 3.0 times
when represented with this format.
Here is an example ascii-hex file. It contains the data “Hello,
World[rq] to be loaded at address 0x1000.
48 65 6C 6C 6F 2C 20 57 6F 72 6C 64 0A ^C
srec_cat version 1.52
Copyright (C) 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005, 2006,
2007, 2008, 2009 Peter Miller
The srec_cat program comes with ABSOLUTELY NO WARRANTY; for details use
the ’srec_cat -VERSion License’ command. This is free software and you
are welcome to redistribute it under certain conditions; for details
use the ’srec_cat -VERSion License’ command.
Peter Miller E-Mail: firstname.lastname@example.org
/\/\* WWW: http://miller.emu.id.au/pmiller/