Provided by: crafty_23.1-1_i386
crafty.rc, .craftyrc - run control for crafty(6)
A Crafty run control file should contain a sequence of valid Crafty
commands, terminated by the command "exit" to restore standard input to
the keyboard. This manual page gives a skeletal example. Even the few
commands used are not fully explained, and should be looked up in
"crafty.doc". As for where the run control file should be, see
# $HOME/.craftyrc (comments like this are fine).
! echo "Reading $HOME/.craftyrc ..."
# Crafty’s shell escape "!" lets us at system commands.
# Echoed information will be in "log.001".
# PROCESSOR USAGE:
# The "mt" command indicates how many processors to use.
# With zero, multiprocessor support is disabled.
# If Crafty has been compiled without SMP support,
# a harmless error message results.
# MEMORY USAGE:
# Memory allowed for transposition hash table.
# Memory for pawn structure hash table.
# These commands are well explained in "crafty.doc".
# Hopefully, someone will step in and rewrite this
# example to properly use the more intricate "adaptive".
# ENDGAME TABLEBASES:
# Enable tablebases.
# The "!" has Crafty pat us on the head if we happen to
# play a good move in the late endgame.
# Define memory usage for caching tablebase probe info.
# OUTPUT TUNING:
# Make Crafty verbose in the opening.
# FINALLY, RESTORE CRAFTY’S INPUT TO THE KEYBOARD:
# End of $HOME/.craftyrc
Robert Hyatt (firstname.lastname@example.org).