Provided by: wireless-tools_30~pre9-3ubuntu4_i386
iwpriv - configure optionals (private) parameters of a wireless network
iwpriv interface private-command [private-parameters]
iwpriv interface private-command [I] [private-parameters]
iwpriv interface --all
Iwpriv is the companion tool to iwconfig(8). Iwpriv deals with
parameters and setting specific to each driver (as opposed to iwconfig
which deals with generic ones).
Without any argument, iwpriv list the available private commands
available on each interface, and the parameters that they require.
Using this information, the user may apply those interface specific
commands on the specified interface.
In theory, the documentation of each device driver should indicate how
to use those interface specific commands and their effect.
Execute the specified private-command on the interface.
The command may optionally take or require arguments, and may
display information. Therefore, the command line parameters may
or may not be needed and should match the command expectations.
The list of commands that iwpriv displays (when called without
argument) should give you some hints about those parameters.
However you should refer to the device driver documentation for
information on how to properly use the command and the effect.
private-command [I] [private-parameters]
Idem, except that I (an integer) is passed to the command as a
Token Index. Only some command will use the Token Index (most
will ignore it), and the driver documentation should tell you
when it’s needed.
Execute and display all the private commands that don’t take any
arguments (i.e. read only).
For each device which support private commands, iwpriv will display the
list of private commands available.
This include the name of the private command, the number or arguments
that may be set and their type, and the number or arguments that may be
display and their type.
For example, you may have the following display :
eth0 Available private ioctl :
setqualthr (89F0) : set 1 byte & get 0
gethisto (89F7) : set 0 & get 16 int
This indicate that you may set the quality threshold and display an
histogram of up to 16 values with the following commands :
iwpriv eth0 setqualthr 20
iwpriv eth0 gethisto
Jean Tourrilhes - firstname.lastname@example.org
iwconfig(8), iwlist(8), iwevent(8), iwspy(8), wireless(7).