Provided by: debhelper_13.11.6ubuntu1_all bug

NAME

       dh_auto_install - automatically runs make install or similar

SYNOPSIS

       dh_auto_install [build system options] [debhelper options] [-- params]

DESCRIPTION

       dh_auto_install is a debhelper program that tries to automatically install built files. It
       does so by running the appropriate command for the build system it detects the package
       uses. For example, if there's a Makefile and it contains a install target, then this is
       done by running make (or MAKE, if the environment variable is set). If there is a setup.py
       or Build.PL, it is used. Note that the Ant build system does not support installation, so
       dh_auto_install will not install files built using Ant.

       In compat 15 or later, dh_auto_install will use debian/tmp as the default --destdir and
       should be moved from there to the appropriate package build directory using dh_install(1)
       or similar tools. Though if the single-binary addon for dh(1) is activated, then it will
       pass an explicit --destdir=debian/package/ to dh_auto_install.

       For earlier compat levels then unless --destdir option is specified, the files are
       installed into debian/package/ if there is only one binary package. In the multiple binary
       package case, the files are instead installed into debian/tmp/, and should be moved from
       there to the appropriate package build directory using dh_install(1) or similar tools.

       DESTDIR is used to tell make where to install the files.  If the Makefile was generated by
       MakeMaker from a Makefile.PL, it will automatically set PREFIX=/usr too, since such
       Makefiles need that.

       This is intended to work for about 90% of packages. If it doesn't work, or tries to use
       the wrong install target, you're encouraged to skip using dh_auto_install at all, and just
       run make install manually.

OPTIONS

       See "BUILD SYSTEM OPTIONS" in debhelper(7) for a list of common build system selection and
       control options.

       --destdir=directory
           Install files into the specified directory. If this option is not specified,
           destination directory is determined automatically as described in the "DESCRIPTION"
           section.

       -- params
           Pass params to the program that is run, after the parameters that dh_auto_install
           usually passes.

SEE ALSO

       debhelper(7)

       This program is a part of debhelper.

AUTHOR

       Joey Hess <joeyh@debian.org>