Provided by: pmdk-tools_1.13.1-1.1ubuntu2_amd64 bug

NAME

       pmempool-sync - Synchronize replicas or their parts within a pool set.

SYNOPSIS

              pmempool sync [options] <poolset_file>

       NOTE: Only the pool set file used to create the pool should be used for syncing the pool.

NOTE

              NOTICE:  The  libpmemblk  and libpmemlog libraries are deprecated since PMDK 1.13.0
              release.

DESCRIPTION

       The pmempool sync command synchronizes data between replicas within a pool set.  It checks
       if  metadata of all replicas in a pool set are consistent, i.e. all parts are healthy, and
       if any of them is not, the corrupted or missing parts are recreated and filled  with  data
       from  one  of  the  healthy  replicas.   Currently  synchronizing data is allowed only for
       pmemobj pools (see libpmemobj(7)).

       If a pool set has the option SINGLEHDR or NOHDRS (see poolset(5)), pmempool  sync  command
       has  limited  capability  of  checking  its  metadata.   This  is  due  to  limited or no,
       respectively, internal metadata at the beginning of pool set parts in every  replica  when
       either of the options is used.  In that cases, only missing parts or the ones which cannot
       be opened are recreated.

   Available options:
       -b, --bad-blocks
              Fix bad blocks - it causes creating or reading special recovery  files.   When  bad
              blocks are detected, special recovery files have to be created in order to fix them
              safely.  A separate recovery file is created  for  each  part  of  the  pool.   The
              recovery  files are created in the same directory where the poolset file is located
              using the following name pattern: <poolset-file-name> _r <replica-number> _p <part-
              number>  _badblocks.txt  These recovery files are automatically removed if the sync
              operation finishes successfully.

              If the last sync operation was interrupted and not  finished  correctly  (eg.   the
              application  crashed)  and the bad blocks fixing procedure was in progress, the bad
              block recovery files may be left over.  In such case bad  blocks  might  have  been
              cleared  and  zeroed, but the correct data from these blocks was not recovered (not
              copied from a healthy replica), so the recovery files MUST NOT be deleted manually,
              because  it  would  cause  a data loss.  Pmempool-sync should be run again with the
              `-b' option set.  It will finish the previously interrupted sync operation and copy
              correct data to zeroed bad blocks using the left-over bad block recovery files (the
              bad blocks will be read from the saved recovery files).  Pmempool will  delete  the
              recovery files automatically at the end of the sync operation.

              Using  this  option  may  have  limitations depending on the operating system.  For
              details see description of the CHECK_BAD_BLOCKS feature in pmempool-feature(1).

       -d, --dry-run
              Enable dry run mode.  In this mode no changes are applied, only check for viability
              of synchronization.

       -v, --verbose
              Increase verbosity level.

       -h, --help
              Display help message and exit.

SEE ALSO

       pmempool(1), libpmemblk(7), libpmemlog(7), libpmempool(7) and <https://pmem.io>