Provided by: libfabric-dev_1.17.0-3build2_amd64 bug

NAME

       fi_mrail - The Multi-Rail Utility Provider

OVERVIEW

       The  mrail  provider  (ofi_mrail)  is  an  utility provider that layers over an underlying
       provider to enable the use of multiple network ports (rails).  This  increases  the  total
       available  bandwidth  of  an underlying provider.  The current status of mrail provider is
       experimental - not all libfabric features are supported and performance is not guaranteed.

REQUIREMENTS

   Requirements for underlying provider
       mrail provider requires the underlying provider to support the  following  capabilities  /
       modes:

       • Buffered receive (FI_BUFFERED_RECV)

       • FI_SOURCE

       • FI_AV_TABLE

   Requirements for applications
       Applications need to: * Support FI_MR_RAW MR mode bit to make use of FI_RMA capability.  *
       Set FI_OFI_MRAIL_ADDR env variable (see RUNTIME PARAMETERS section below).

SUPPORTED FEATURES

       Endpoint types
              The provider supports only FI_EP_RDM.

       Endpoint capabilities
              The following data transfer interface is supported: FI_MSG, FI_TAGGED, FI_RMA.

       # LIMITATIONS
              Limitations of the underlying provider may show  up  as  that  of  mrail  provider.
              mrail  provider  doesn’t  allow  pass-through  of  any  mode bits to the underlying
              provider.

   Unsupported features
       The following are the major libfabric features that are not supported.  Any other  feature
       not listed in “Supported features” can be assumed as unsupported.

       • FI_ATOMIC

       • Scalable endpoints

       • Shared contexts

       • FABRIC_DIRECT

       • Multicast

       • Triggered operations

FUNCTIONALITY OVERVIEW

       For  messages  (FI_MSG,  FI_TAGGED), the provider uses different policies to send messages
       over one or more rails based on message  size  (See  FI_OFI_MRIAL_CONFIG  in  the  RUNTIME
       PARAMETERS section).  Ordering is guaranteed through the use of sequence numbers.

       For RMA, the data is striped equally across all rails.

RUNTIME PARAMETERS

       The ofi_mrail provider checks for the following environment variables.

       FI_OFI_MRAIL_ADDR
              Comma  delimited list of individual rail addresses.  Each address can be an address
              in FI_ADDR_STR format, a host name, an IP address, or a netdev interface name.

       FI_OFI_MRAIL_ADDR_STRC
              Deprecated.  Replaced by FI_OFI_MRAIL_ADDR.

       FI_OFI_MRAIL_CONFIG
              Comma separated list of <max_size>:<policy> pairs, sorted  in  ascending  order  of
              <max_size>.  Each pair indicated the rail sharing policy to be used for messages up
              to the size <max_size> and not  covered  by  all  previous  pairs.   The  value  of
              <policy>  can  be  fixed (a fixed rail is used), round-robin (one rail per message,
              selected in round-robin fashion), or striping (striping across all the rails).  The
              default  configuration  is 16384:fixed,ULONG_MAX:striping.  The value ULONG_MAX can
              be input as -1.

SEE ALSO

       fabric(7), fi_provider(7), fi_getinfo(3)

AUTHORS

       OpenFabrics.