Provided by:
shorewall_4.4.21-1_all 
NAME
blacklist - Shorewall Blacklist file
SYNOPSIS
/etc/shorewall/blacklist
DESCRIPTION
The blacklist file is used to perform static blacklisting. You can
blacklist by source address (IP or MAC), or by application.
The columns in the file are as follows.
ADDRESS/SUBNET - {-|~mac-address|ip-address|address-range|+ipset}
Host address, network address, MAC address, IP address range (if
your kernel and iptables contain iprange match support) or ipset
name prefaced by "+" (if your kernel supports ipset match).
Exclusion (shorewall-exclusion[1](5)) is supported.
MAC addresses must be prefixed with "~" and use "-" as a separator.
Example: ~00-A0-C9-15-39-78
A dash ("-") in this column means that any source address will
match. This is useful if you want to blacklist a particular
application using entries in the PROTOCOL and PORTS columns.
PROTOCOL (Optional) - {-|[!]protocol-number|[!]protocol-name}
If specified, must be a protocol number or a protocol name from
protocols(5).
PORTS (Optional) - {-|[!]port-name-or-number[,port-name-or-number]...}
May only be specified if the protocol is TCP (6) or UDP (17). A
comma-separated list of destination port numbers or service names
from services(5).
OPTIONS (Optional - Added in 4.4.12) -
{-|{dst|src|whitelist|audit}[,...]}
If specified, indicates whether traffic from ADDRESS/SUBNET (src)
or traffic to ADDRESS/SUBNET (dst) should be blacklisted. The
default is src. If the ADDRESS/SUBNET column is empty, then this
column has no effect on the generated rule.
Note
In Shorewall 4.4.12, the keywords from and to were used in
place of src and dst respectively. Blacklisting was still
restricted to traffic arriving on an interface that has the
'blacklist' option set. So to block traffic from your local
network to an internet host, you had to specify blacklist on
your internal interface in shorewall-interfaces[2] (5).
Note
Beginning with Shorewall 4.4.13, entries are applied based on
the blacklist setting in shorewall-zones[3](5):
1. 'blacklist' in the OPTIONS or IN_OPTIONS column. Traffic
from this zone is passed against the entries in this file
that have the src option (specified or defaulted).
2. 'blacklist' in the OPTIONS or OUT_OPTIONS column. Traffic
to this zone is passed against the entries in this file
that have the dst option.
In Shorewall 4.4.20, the whitelist option was added. When whitelist
is specified, packets/connections that match the entry are not
matched against the remaining entries in the file.
The audit option was also added in 4.4.20 and causes packets
matching the entry to be audited. The audit option may not be
specified in whitelist entries and require AUDIT_TARGET support in
the kernel and iptables.
EXAMPLE
Example 1:
To block DNS queries from address 192.0.2.126:
#ADDRESS/SUBNET PROTOCOL PORT
192.0.2.126 udp 53
Example 2:
To block some of the nuisance applications:
#ADDRESS/SUBNET PROTOCOL PORT
- udp 1024:1033,1434
- tcp 57,1433,1434,2401,2745,3127,3306,3410,4899,5554,6101,8081,9898
FILES
/etc/shorewall/blacklist
SEE ALSO
http://shorewall.net/blacklisting_support.htm
shorewall(8), shorewall-accounting(5), shorewall-actions(5),
shorewall-hosts(5), shorewall_interfaces(5), shorewall-ipsets(5),
shorewall-maclist(5), shorewall-masq(5), shorewall-nat(5),
shorewall-netmap(5), shorewall-params(5), shorewall-policy(5),
shorewall-providers(5), shorewall-proxyarp(5),
shorewall-route_rules(5), shorewall-routestopped(5),
shorewall-rules(5), shorewall.conf(5), shorewall-secmarks(5),
shorewall-tcclasses(5), shorewall-tcdevices(5), shorewall-tcrules(5),
shorewall-tos(5), shorewall-tunnels(5), shorewall-zones(5)
NOTES
1. shorewall-exclusion
http://www.shorewall.net/manpages/shorewall-exclusion.html
2. shorewall-interfaces
http://www.shorewall.net/manpages/shorewall-interfaces.html
3. shorewall-zones
http://www.shorewall.net/manpages/shorewall-zones.html
[FIXME: source] 07/10/2011 SHOREWALL-BLACKLIST(5)