Provided by: freebsd-manpages_8.2-1_all bug

NAME

     bwn -- Broadcom BCM43xx IEEE 802.11b/g wireless network driver

SYNOPSIS

     To compile this driver into the kernel, place the following lines in your
     kernel configuration file:

           device siba_bwn
           device bwn
           device wlan
           device wlan_amrr
           device firmware

     Alternatively, to load the driver as a module at boot time, place the
     following line in loader.conf(5):

           if_bwn_load="YES"

DESCRIPTION

     The bwn driver provides support for Broadcom BCM43xx based PCI/CardBus
     network adapters.

     It supports station and monitor mode operation.  Only one virtual
     interface may be configured at any time.  For more information on
     configuring this device, see ifconfig(8).

     This driver requires firmware to be loaded before it will work.  The
     ports/net/bwn-firmware-kmod port needs to be installed before ifconfig(8)
     will work.  Most cases you need to use bwn_v4_ucode module but if you are
     a LP (low power) PHY user please uses bwn_v4_lp_ucode module.

HARDWARE

     The bwn driver supports Broadcom BCM43xx based wireless devices,
     including:

           Card                     Chip       Bus         Standard
           Apple Airport Extreme    BCM4306    PCI         b/g
           Apple Airport Extreme    BCM4318    PCI         b/g
           ASUS WL-138g             BCM4318    PCI         b/g
           Buffalo WLI-CB-G54S      BCM4318    CardBus     b/g
           Buffalo WLI-PCI-G54S     BCM4306    PCI         b/g
           Compaq R4035 onboard     BCM4306    PCI         b/g
           Dell Wireless 1470       BCM4318    Mini PCI    b/g
           Dell Truemobile 1400     BCM4309    Mini PCI    b/g
           HP nx6125                BCM4319    PCI         b/g
           Linksys WPC54G Ver 3     BCM4318    CardBus     b/g
           Linksys WPC54GS Ver 2    BCM4318    CardBus     b/g
           TRENDnet TEW-401PCplus   BCM4306    CardBus     b/g
           US Robotics 5411         BCM4318    CardBus     b/g

EXAMPLES

     Join an existing BSS network (i.e., connect to an access point):

           ifconfig wlan create wlandev bwn0 inet 192.168.0.20 \
               netmask 0xffffff00

     Join a specific BSS network with network name ``my_net'':

           ifconfig wlan create wlandev bwn0 ssid my_net up

     Join a specific BSS network with 64-bit WEP encryption:

           ifconfig wlan create wlandev bwn0 ssid my_net \
                   wepmode on wepkey 0x1234567890 weptxkey 1 up

SEE ALSO

     arp(4), cardbus(4), intro(4), pci(4), wlan(4), wlan_amrr(4), ifconfig(8),
     wpa_supplicant(8)

HISTORY

     The bwn driver first appeared in FreeBSD 8.1.

AUTHORS

     The bwn driver was written by Weongyo Jeong <weongyo@FreeBSD.org>.