Provided by: freebsd-manpages_8.2-1_all
epair -- A pair of virtual back-to-back connected Ethernet interfaces.
To compile this driver into the kernel, place the following line in your
kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
The epair is a pair of Ethernet-like software interfaces, which are
connected back-to-back with a virtual cross-over cable.
Each epair interface pair is created at runtime using interface cloning.
This is most easily done with the ifconfig(8) create command or using the
cloned_interfaces variable in rc.conf(5). While for cloning you only
give either epair or epair<n> the epair pair will be named like
epair<n>[ab]. This means the names of the first epair interfaces will be
epair0a and epair0b.
Like any other Ethernet interface, an epair needs to have a network
address. Each epair will be assigned a locally administered address by
default, that is only guaranteed to be unique within one network stack.
To change the default addresses one may use the SIOCSIFADDR ioctl(2) or
The basic intend is to provide connectivity between two virtual network
stack instances. When connected to a if_bridge(4) one end of the
interface pair can also be part of another (virtual) LAN. As with any
other Ethernet interface one can configure vlan(4) support on top of it.
ioctl(2), altq(4), bpf(4), if_bridge(4), vlan(4), loader.conf(5,)
The epair interface first appeared in FreeBSD 8.0.
The epair interface was written by Bjoern A. Zeeb, CK Software GmbH,
under sponsorship from the FreeBSD Foundation.