Provided by: nut-server_2.6.1-2ubuntu2_i386
upsd.conf - Configuration for Network UPS Tools upsd
upsd uses this file to control access to the server and set some other
miscellaneous configuration values. This file contains details on
access controls, so keep it secure. Ideally, only the upsd process
should be able to read it.
upsd usually allows a driver to stop responding for up to 15
seconds before declaring the data "stale". If your driver takes a
very long time to process updates but is otherwise operational, you
can use MAXAGE to make upsd wait longer.
Most users should leave this at the default value.
Tell upsd to look for the driver state sockets in path rather than
the default that was compiled into the program.
"LISTEN interface port"
Bind a listening port to the interface specified by its Internet
address. This may be useful on hosts with multiple interfaces. You
should not rely exclusively on this for security, as it can be
subverted on many systems.
Listen on TCP port port instead of the default value which was
compiled into the code. This overrides any value you may have set
with configure --with-port. If you don't change it with configure
or this value, upsd will listen on port 3493 for this interface.
Multiple LISTEN addresses may be specified. The default is to bind
to 127.0.0.1 if no LISTEN addresses are specified (and ::1 if IPv6
support is compiled in).
This parameter will only be read at startup. You'll need to restart
(rather than reload) upsd to apply any changes made here.
This defaults to maximum number allowed on your system. Each UPS,
each LISTEN address and each client count as one connection. If the
server runs out of connections, it will no longer accept new
incoming client connections. Only set this if you know exactly what
"CERTFILE certificate file"
When compiled with SSL support, you can enter the certificate file
here. The certificates must be in PEM format and must be sorted
starting with the subject's certificate (server certificate),
followed by intermediate CA certificates (if applicable_ and the
highest level (root) CA. It should end with the server key. See
docs/security.txt or the Security chapter of NUT user manual for
more information on the SSL support in NUT.
upsd(8), nutupsdrv(8), upsd.users(5)
The NUT (Network UPS Tools) home page: http://www.networkupstools.org/