Provided by: oss4-base_4.2-build2004-1ubuntu2_i386
oss_digi96 - RME Digi96 professional audio driver.
Audio driver for the RME Digi96 family of profressional audio
o Only 16 and 24/32 bit audio formats are supported.
o All Digi96 family members support 32kHz, 44.1kHz, 48kHz, 64kHz,
88.2kHz and 96kHz. sampling rates.
Note! For recording you need to set digi96.sync to INTERNAL and the
values of digi96.mode and digi96.input to match your studio setup.
Otherwise recordings will fail with I/O error.
There are several settings that can be changed using the ossmix program
shipped with OSS. Note that some features don't work with all Digi96
family members. For example ADAT mode is not supported by the base
o digi96.mode <SPDIF|AESEBU|ADAT>: This setting controls the output
mode which can be S/PDIF (consumer), AES/EBU (professional) or ADAT.
The input mode is detected automatically. If ADAT input is detected
the output mode will be switched to ADAT automatically (this doesn't
work in the other direction).
o digi96.sync <EXTERNAL|INTERNAL>: This setting tells if the playback
sampling rate is based on the internal oscillator or the sample rate
detected in the input port. See also the definition of the
o digi96.input <OPTICAL|COAXIAL|INTERNAL|XLR>: Selects the active
o digi96.sel <BYPASS|NORMAL>: When set to BYPASS the input signal will
be routed directly to the output (also sets digi96.sync
automatically to EXTERNAL). In this mode audio data written to
/dev/dsp will be muted.
o digi96.worldclk ON|OFF: Setting this control to ON will enable the
optional worldclock input as the sample rate source (overrides the
o digi96.emph ON|OFF: Enables/disables the de-emphasis option on the
analog (monitor) output connector.
o digi96.data <AUDIO|AC3>: Specifies if the output signal is audio or
AC3 data (sets the non-audio bit in the channel status data).
/etc/oss4/conf/oss_digi96.conf Device configuration file
27 September 2011 oss_digi96(7)