Provided by: shapetools_1.4pl6-11_i386 bug

NAME

       shape stdrul - shapeTools RMS general version selection rules

DESCRIPTION

       The  shape release management system requires a set of standard version
       selection rules to be accessible project wide. These are defined in the
       stdrules  file, which is to be included into the Shapefiles of any part
       of the system controlled by the shapeTools release  management  system.
       Version  selection  rules  drive  the binding of component names in the
       Shapefile to specific versions during a build or  release  process  (or
       better:  any  process  performed  by  invocation  of  shape(1)  ). Some
       functions of shape_RMS allow definition of  the  version  binding  rule
       being  active  by defining the VERSIONS macro on the command line. This
       may be set to any of the rule names listed below.

       If you want to introduce new version selection rules for  project  wide
       use, you may add them to the stdrules file. You should be very careful,
       when altering this file. Do not remove any of the rules defined in  the
       original   version  of  stdrules  (as  it  comes  from  the  shapeTools
       distribution  tape)  because  these  are  essential  for  the   release
       management  system.  When altering one of the original selection rules,
       you should be very concious of what you are doing, as  you  may  affect
       the  operationality  of  shape  RMS. For a description of the syntax of
       rule definitions, see the shape(1) manual.

       The standard version selection rules are:

       most_recent
                 For each component select a busy version  if  available,  the
                 most recent saved version otherwise.

       last_proposed
                 Use  the  last  proposed version of each component. This rule
                 fails, if no proposed version is available

       last_released
                 Select versions from the last generated release.

       last_prereleased
                 Select versions from the last generated prerelease.

       recent_release
                 Select versions included in the last release  or  prerelease,
                 whichever is newer.

       from_release
                 Select  versions from a specific release or prerelease.  When
                 using this rule the value of the macro RELEASENAME has to  be
                 set to the name of the desired (pre)release.

       extern    Always select a busy version (a regular UNIX file). This rule
                 should be applied to all extern components that are not under
                 control of the shapeTools version control system.

FILES

       $(SHAPELIBPATH)/stdrules

SEE ALSO

       shape_RMS(1), shape(1)