Provided by: dbus_1.4.18-1ubuntu1_amd64 bug


       dbus-send - Send a message to a message bus


       dbus-send  [--system | --session] [--dest=NAME] [--print-reply] [--type=TYPE] <destination
       object path> <message name> [contents ...]


       The  dbus-send  command  is  used  to  send  a  message  to  a  D-Bus  message  bus.   See for more information about the big picture.

       There  are  two  well-known  message  buses: the systemwide message bus (installed on many
       systems as the "messagebus" service) and the per-user-login-session message  bus  (started
       each  time  a  user logs in).  The --system and --session options direct dbus-send to send
       messages to the system or session buses respectively.  If neither is specified,  dbus-send
       sends to the session bus.

       Nearly  all  uses  of  dbus-send  must  provide the --dest argument which is the name of a
       connection on the bus to send the message to. If --dest is omitted, no destination is set.

       The object path and the name of the message to send must always  be  specified.  Following
       arguments,  if  any,  are  the  message  contents (message arguments).  These are given as
       type-specified values  and  may  include  containers  (arrays,  dicts,  and  variants)  as
       described below.

       <contents>   ::= <item> | <container> [ <item> | <container>...]
       <item>       ::= <type>:<value>
       <container>  ::= <array> | <dict> | <variant>
       <array>      ::= array:<type>:<value>[,<value>...]
       <dict>       ::= dict:<type>:<type>:<key>,<value>[,<key>,<value>...]
       <variant>    ::= variant:<type>:<value>
       <type>       ::= string | int16 | uint 16 | int32 | uint32 | int64 | uint64 | double | byte | boolean | objpath

       D-Bus  supports  more types than these, but dbus-send currently does not.  Also, dbus-send
       does not permit empty containers or nested containers (e.g. arrays of variants).

       Here is an example invocation:

         dbus-send --dest=org.freedesktop.ExampleName               \
                   /org/freedesktop/sample/object/name              \
                   org.freedesktop.ExampleInterface.ExampleMethod   \
                   int32:47 string:'hello world' double:65.32       \
                   array:string:"1st item","next item","last item"  \
                   dict:string:int32:"one",1,"two",2,"three",3      \
                   variant:int32:-8                                 \

       Note that the interface is separated from a method or signal name by a dot, though in  the
       actual protocol the interface and the interface member are separate fields.


       The following options are supported:

              Specify the name of the connection to receive the message.

              Block for a reply to the message sent, and print any reply received.

              Send to the system message bus.

              Send to the session message bus.  (This is the default.)

              Specify "method_call" or "signal" (defaults to "signal").


       dbus-send was written by Philip Blundell.


       Please   send   bug   reports   to   the   D-Bus   mailing   list   or  bug  tracker,  see