Provided by: ax25-tools_0.0.8-13.2_amd64 bug

NAME

       dmascc_cfg - Configure dmascc devices

SYNOPSIS

       dmascc <interface> [<options>]

DESCRIPTION

       dmascc_cfg  is  used  to  configure  dmascc  devices such as PI2 and PackeTwin cards.  The
       --show option can be used by any user, all other options must be used by root.

OPTIONS

       --speed frequency
                 Set frequency of baud rate generator to frequency. A value  of  0  disables  the
                 baud  rate generator and the digital PLL. Use the --show option to check whether
                 the frequency you selected could be approximated with sufficient accuracy.

       --nrzi [0|1]
                 0 selects NRZ mode, 1 selects NRZI mode.

       --clocks integer
                 Set the clock mode. You may OR together three  choices  (other  values  are  not
                 supported and may cause strange results).

       TX clock pin:

              0x00 input
              0x05 output TX clock *
              0x06 output baud rate generator *
              0x07 output digital PLL *

       TX clock source:

              0x00 RX clock pin
              0x08 TX clock pin #
              0x10 baud rate generator
              0x18 digital PLL +

       RX clock source:

              0x00 RX clock pin
              0x20 TX clock pin
              0x40 baud rate generator
              0x60 digital PLL +

       * Not allowed on PI2 Port A if J3 is installed.

       # TX clock pin must be configured as input.

       + Speed must be equal to 32 times the baud rate.

       --txdelay milliseconds
                 Set transmit delay to milliseconds. Maximum is 2500 ms.

       --txtime seconds
                 Set maximum time the transmitter may be active to seconds.

       --sqdelay milliseconds
                 Set the squelch delay to milliseconds. Maximum delay is 2500 ms.

       --slottime milliseconds
                 Set the slot time to milliseconds. Maximum slottime is 2500 ms.

       --waittime milliseconds
                 Set  the minimum time between the transmitter turning off to when it turns on to
                 milliseconds. Maximum wait time is 2500 ms.

       --persist f
                 Set the persistance parameter to f. Must be between 0 and 255 (inclusive).

       --dma channel
                 Set the DMA channel to channel. Can be 1 or 3.  Setting to 0 disables DMA.

BUGS

       dmascc_cfg does not check the parameters for validity. The driver or kernel may  crash  if
       you specify invalid values.

AUTHORS

       Klaus Kudielka
       This manual page written by Craig Small <csmall@small.dropbear.id.au>