Provided by: wml_2.0.11ds2-1build2_i386
htmlstrip - Strip HTML markup code
htmlstrip [-o outputfile] [-O level] [-b blocksize] [-v] [inputfile]
HTMLstrip reads inputfile or from "stdin" and strips the contained HTML
markup. Use this program to shrink and compactify your HTML files in a
Recognized Content Types
There are three disjunct types of content which are recognized by
HTMLstrip while parsing:
HTML Tag (tag)
This is just a single HTML tag, i.e. a string beginning with a
opening angle bracket directly followed by an identifier,
optionally followed by attributes and ending with a closing angle
This is any contents enclosed in one of the following container
The non-HTML-3.2-conforming "<nostrip>" tag is special here: It
acts like "<pre>" as a protection container for HTMLstrip but is
also stripped from the output. Use this as a pseudo-block which
just preserves its body for the HTMLstrip processing but itself is
removed from the output.
Plain Text (txt)
This is anything not falling into one of the two other categories,
i.e any content both outside of preformatted areas and outside of
Supported Stripping Levels
The amount of stripping can be controlled by a optimization level,
specified via option -O (see below). Higher levels also include all of
the lower levels. The following stripping is done on each level:
No real stripping, just removing the sharp/comment-lines ("#...")
[txt,tag]. Such lines are a standard feature of WML, so this is
Minimal stripping: Same as level 0 plus stripping of blank and
empty lines [txt].
Good stripping: Same as level 1 plus compression of multiple
whitespaces (more then one in sequence) to single whitespaces
[txt,tag] and stripping of trailing whitespaces at the of of a line
This level is the default because while providing good optimization
the HTML markup is not destroyed and remains human readable.
Best stripping: Same as level 2 plus stripping of leading
whitespaces on a line [txt]. This can also be recommended when you
still want to make sure that the HTML markup is not destroyed in
any case. But the resulting code is a little bit ugly because of
the removed whitespaces.
Expert stripping: Same as level 3 plus stripping of HTML comment
lines (``"<!-- ... -->"'') and crunching of HTML tag endsi [tag].
BE CAREFUL HERE: Comment lines are widely used for hiding some Java
those stuff. When using this optimization level make sure all your
"<nostrip>" tags around the comment delimiters.
Crazy stripping: Same as level 4 plus wrapping lines around to fit
in an 80 column view window. This saves some newlines but both
leads to really unreadable markup code and opens the window for a
lot of problems when this code is used to layout the page in a
browser. Use with care. This is only experimental!
Additionally the following global strippings are done:
A leading newline is always stripped.
The "<suck>" tag just absorbs itself and all whitespaces around it.
This is like the backslash for line-continuation, but is done in
Pass 8, i.e. really at the end. Use this inside HTML tag
definitions to absorb whitespaces, for instance around %body when
used inside "<table>" structures which at some point are newline-
sensitive in Netscape Navigator.
This redirects the output to outputfile. Usually the output will be
send to "stdout" if no such option is specified or outputfile is
This sets the optimization/stripping level, i.e. how much HTMLstrip
should compress the contents.
For efficiency reasons, input is divided into blocks of 16384
chars. If you have some performance problems, you may try to
change this value. Any value between 1024 and 32766 is allowed.
With a value of 0, input is not divided into blocks.
-v This sets verbose mode where some processing information will be
given on the console.
Ralf S. Engelschall