Provided by: freebsd-manpages_8.2-1_all
ae — Attansic/Atheros L2 FastEthernet controller driver
To compile this driver into the kernel, place the following lines in your kernel configuration file: device miibus device ae Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): if_ae_load="YES"
The ae device driver provides support for Attansic/Atheros L2 PCIe FastEthernet controllers. The controller supports hardware Ethernet checksum processing, hardware VLAN tag stripping/insertion and an interrupt moderation mechanism. Attansic L2 also features a 64-bit multicast hash filter. The ae driver supports the following media types: autoselect Enable autoselection of the media type and options. The user can manually override the autoselected mode by adding media options to rc.conf(5). 10baseT/UTP Select 10Mbps operation. 100baseTX Set 100Mbps (FastEthernet) operation. The ae driver provides support for the following media options: full-duplex Force full duplex operation. half-duplex Force half duplex operation. For more information on configuring this device, see ifconfig(8).
The ae driver supports Attansic/Atheros L2 PCIe FastEthernet controllers, and is known to support the following hardware: · ASUS EeePC 701 · ASUS EeePC 900 Other hardware may or may not work with this driver.
Tunables can be set at the loader(8) prompt before booting the kernel or stored in loader.conf(5). hw.ae.msi_disable This tunable disables MSI support on the Ethernet hardware. The default value is 0.
The ae driver collects a number of useful MAC counter during the work. The statistics is available via the dev.ae.%d.stats sysctl(8) tree, where %d corresponds to the controller number.
ae%d: watchdog timeout. The device has stopped responding to the network, or there is a problem with the network connection (cable). ae%d: reset timeout. The card reset operation has been timed out. ae%d: Generating random ethernet address. No valid Ethernet address was found in the controller NVRAM and registers. Random locally administered address with ASUS OUI identifier will be used instead.
The Attansic L2 FastEthernet contoller supports DMA but does not use a descriptor based transfer mechanism via scatter-gather DMA. Thus the data should be copied to/from the controller memory on each transmit/receive. Furthermore, a lot of data alignment restrictions apply. This may introduce a high CPU load on systems with heavy network activity. Luckily enough this should not be a problem on modern hardware as L2 does not support speeds faster than 100Mbps.
The ae driver and this manual page was written by Stanislav Sedov ⟨stas@FreeBSD.org⟩. It first appeared in FreeBSD 7.1.