Provided by: freebsd-manpages_8.2-1_all
ce -- driver for synchronous Cronyx Tau-PCI/32 WAN adapters
To compile this driver into the kernel, place the following line in your
kernel configuration file:
Alternatively, to load the driver as a module at boot time, place the
following line in loader.conf(5):
The ce driver needs either sppp(4) or netgraph(4). Which one to use is
determined by the NETGRAPH_CRONYX option. If this option is present in
your kernel configuration file, the ce driver will be compiled with
netgraph(4) support. Otherwise, it will be compiled with sppp(4)
Refer to sconfig(8) for information about the ce adapter configuration.
The ce driver supports the following models of Tau-PCI/32 WAN adapters:
Cronyx Tau-PCI/32 two fractional/unframed E1 interfaces, with 32 HDLC
channels shared between them with total adapter
throughput 2048 kbps.
single fractional/unframed E1 interface, with 32
cp(4), ctau(4), cx(4), sppp(4), ifconfig(8), sconfig(8), spppcontrol(8)
The ce driver was added in FreeBSD 6.2, FreeBSD 5.5 and FreeBSD 4.11.
The ce driver for previous versions of FreeBSD is available from