Provided by: freebsd-manpages_8.2-1_all
lo — software loopback network interface
The loop interface is a software loopback mechanism which may be used for
performance analysis, software testing, and/or local communication. As
with other network interfaces, the loopback interface must have network
addresses assigned for each address family with which it is to be used.
These addresses may be set or changed with the SIOCSIFADDR ioctl(2). The
loopback interface should be the last interface configured, as protocols
may use the order of configuration as an indication of priority. The
loopback should never be configured first unless no hardware interfaces
If the transmit checksum offload capability flag is enabled on a loopback
interface, checksums will not be generated by IP, UDP, or TCP for packets
sent on the interface.
If the receive checksum offload capability flag is enabled on a loopback
interface, checksums will not be validated by IP, UDP, or TCP for packets
received on the interface.
By default, both receive and transmit checksum flags will be enabled, in
order to avoid the overhead of checksumming for local communication where
data corruption is unlikely. If transmit checksum generation is
disabled, then validation should also be disabled in order to avoid
packets being dropped due to invalid checksums.
lo%d: can't handle af%d. The interface was handed a message with
addresses formatted in an unsuitable address family; the packet was
The lo device appeared in 4.2BSD. The current checksum generation and
validation avoidance policy appeared in FreeBSD 8.0.