Provided by: wicd-daemon_1.7.2.3-1_all bug

NAME

       wicd-manager-settings.conf  -  contains  settings  that  control Wicd's
       behavior

DESCRIPTION

       This file contains general configuration information for Wicd.
       This file is located at /etc/wicd/manager-settings.conf

SETTINGS

       link_detect_tool = <0|1|2>
              0 = autodetect
              1 = ethtool
              2 = mii-tool

       flush_tool = <0|1|2>
              0 = autodetect
              1 = ip
              2 = route

       backend = <ioctl|external>
              Default is ioctl backend.

       signal_display_type = <0|1>
              0 = Show signal strength as a percentage
              1 = Show signal strength in dBm

       dhcp_client = <0|1|2|3>
              0 = autodetect
              1 = dhclient
              2 = dhcpcd
              3 = pump

       sudo_app = <0|1|2|3>
              0 = autodetect
              1 = gksu
              2 = kdesu
              3 = ktsuss

       wired_interface = <interface_name>

       always_show_wired_interface = <True|False>

       wired_connect_mode = <0|1>
              0 = connect to wired interface automatically
              1 = do not connect to wired interface automatically

       prefer_wired = <True|False>
              True = Switch to wired interface if a link is detected, even  if
              already connected to wireless
              False = Do not switch to wired interface automatically

       wireless_interface = <name_of_wireless_interface>

       wpa_driver                                                            =
       <wext|madwifi|ndiswrapper|hostap|hermes|atmel|broadcom|ipw|ralinklegacy|none>
              The  default  (and  best  supported)  is  wext.   It should work
              properly in most cases.  The none special value makes WICD  pass
              no -D parameter to wpa_supplicant, which might be useful in some
              cases.

       auto_reconnect = <True|False>
              This settings determines whether Wicd will attempt to  reconnect
              on connection loss.

       use_global_dns = <True|False>
              If  set  to  "True"  and  values are specified in the global DNS
              settings below, this will cause Wicd to use these DNS settings.

       global_dns_dom = <plaintext_domain_name>
              This specifies the default search  domain  to  be  used  by  the
              resolver.

       global_dns_1 = <ip_address>

       global_dns_2 = <ip_address>

       global_dns_3 = <ip_address>

       debug_mode = <integer_value>
              0 = disabled
              1 = enabled

SEE ALSO

       wicd(8),  wicd-curses(8),  wicd-wired-settings.conf(5),  wicd-wireless-
       settings.conf(5).

                                 wicd-1.7.2.3    WICD-MANAGER-SETTINGS.CONF(5)