Provided by: toppler_1.1.4-2_i386
toppler - clone of the old "Nebulous" game
toppler [-f] [-h] [-s] [-dNUM ]
This manual page documents briefly the toppler command.
The goal of the game is to reach the target door of each of the 8
towers in currently 2 missions with this little green animal. This door
is usually at the very top of the tower.
But finding the way by using elevators and walking trough a maze of
doors and platforms is not the only problem you have to solve. There
are a bunch of other creatures living on the tower that will hinder you
to reach your target by pushing you over the edge of the platforms.
The only weapon of defence you have is to throw a little snowball. But
most of the other creatures just don't care about this. So you must
A little submarine brings you from one tower to the next. On this way
you have the chance to get some bonus points by catching fish. All you
have to do is to catch a fish in a bubble with your torpedo and then
collect the fish.
In the menu you can select the mission you want to play next with the
left and right cursor keys. Press space or return on the start menu
item to start the game.
The animal is controlled by the cursor keys and space (or return).
Left and right make the animal walk. Up and down make the elevators
move if you are on one. (The elevator platforms are a little bit
smaller than the normal platforms.) If you are in front of a door
press up to enter it. Pressing the space key will either throw a
snowball if you are standing still or make the animal jump if you are
In the level designer, press F1 or h for the online help.
The program understands the following command line options.
-f Starts the game in fullscreen mode. But be careful! If the game
crashes it doesn't restore the original resolution, it stays in
640x480 pixel mode.
-h Display short usage information and exit.
-s Makes the game silent. If you don't have a soundcard or for
another reason get an "can't open audio" error try this option.
-dNUM Sets the debugging level; NUM is between 0 and 9, and the higher
it is, the more information toppler will print out to the
console. (The default debugging level is 0.)
Toppler was written by Andreas Rover <email@example.com>. Later Pasi
Kallinen contributed a lot of code.
This manual page was written by Ben Bell <firstname.lastname@example.org> for the
Debian GNU/Linux system (but may be used by others). It was revised by
Dylan Thurston <email@example.com>, and by Bill Allombert